Nissan Murano. Manual — part 1518
WW-140
< REMOVAL AND INSTALLATION >
RAIN SENSOR
RAIN SENSOR
Exploded View
INFOID:0000000009719784
CAUTION:
When the rain sensor is removed from windshield, the rain sensor cannot be re-used.
REMOVAL
Removal and Installation
INFOID:0000000009719785
REMOVAL
1.
Remove the inside mirror cover (upper and lower).
2.
Disengage the both sides of metal spring clips, and remove the rain sensor from the windshield.
3.
Disconnect rain sensor connector.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Surface of windshield should be cleaned.
• Never touch gel/adhesive of new part.
• Lock the metal spring clips and install the rain sensor securely.
1.
Rain sensor connector
2.
Inside mirror cover (upper)
3.
Inside mirror cover (lower)
4.
Rain sensor
A.
Metal spring clip
Refer to
for symbols in the figure.
JPLIA0817ZZ
WIPER AND WASHER SWITCH
WW-141
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
WIPER AND WASHER SWITCH
Exploded View
INFOID:0000000009719786
WW-142
< REMOVAL AND INSTALLATION >
REAR WIPER ARM
REAR WIPER ARM
Exploded View
INFOID:0000000009719787
Removal and Installation
INFOID:0000000009719788
REMOVAL
1.
Operate the rear wiper to the auto stop position.
2.
Remove rear wiper arm cover.
3.
Remove the rear wiper arm mounting nut.
4.
Raise rear wiper arm, and remove wiper arm from the vehicle.
INSTALLATION
1.
Clean wiper arm mount as shown in the figure to prevent nut
from being loosened.
2.
Operate the rear wiper motor to the auto stop position.
3.
Adjust the rear wiper blade position. Refer to
4.
Install the rear wiper arm by tightening the mounting nut.
5.
Inject the washer fluid.
6.
Operate the rear wiper to the auto stop position.
7.
Check that the rear wiper blades stop at the specified position.
8.
Install rear wiper arm cover.
Adjustment
INFOID:0000000009719789
REAR WIPER BLADE POSITION ADJUSTMENT
Clearance between the end of back door glass and top of wiper blade center.
1.
Rear wiper blade
2.
Rear wiper motor
3.
Pivot seal
4.
Rear wiper arm
5.
Rear wiper arm cover
Refer to
for symbols in the figure.
JPLIA1428GB
SKIA0082J
REAR WIPER ARM
WW-143
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
Standard clearance
L
: 48.8
±
7.5 mm (1.92
±
0.295 in)
JPLIA0966ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст