Nissan Murano. Manual — part 95
AV-158
< REMOVAL AND INSTALLATION >
[BASE AUDIO WITH COLOR DISPLAY]
USB CONNECTOR
USB CONNECTOR
Removal and Installation
INFOID:0000000009721690
REMOVAL
1.
Remove console finisher assembly. Refer to
.
2.
Press the pawl from the back of lower console assembly to remove USB connector.
INSTALLATION
Install in the reverse order of removal.
AV
REAR VIEW CAMERA
AV-159
< REMOVAL AND INSTALLATION >
[BASE AUDIO WITH COLOR DISPLAY]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
REAR VIEW CAMERA
Exploded View
INFOID:0000000009721691
Removal and Installation
INFOID:0000000009721692
REMOVAL
1.
Remove back door finisher inner. Refer to
2.
Remove finisher.
3.
Remove rear view camera screws, disconnect rear view camera connector and remove rear view camera
from back door assembly.
INSTALLATION
Install in the reverse order of removal.
Adjustment
INFOID:0000000009721693
Adjust the guide line position if the guide line position is shifted after installing the rear view camera.
1.
Rear view camera
2.
Finisher
JPNIA0797ZZ
AV-160
< REMOVAL AND INSTALLATION >
[BASE AUDIO WITH COLOR DISPLAY]
REAR VIEW CAMERA
1.
Draw lines on rearward area of the vehicle passing through the
following points: 200 mm (7.87 in) from both sides of the vehicle,
and 0.5 m (1.64 ft), 1.0 m (3.28 ft) from the rear end of the
bumper.
2.
Set into “Adjust Guide Lines” mode of “Confirmation/Adjust-
ment” mode.
3.
Rotate the center dial, and then select the guiding line pattern so
that its angle is aligned with the correction line of the rear of the
vehicle.
4.
Make fine adjustment to the correction line of the rear of the
vehicle with up/down/left/right switches so that its position is
aligned with the guiding line. Press “OK” switch and record the
adjusted guiding line position to the AV control unit.
CAUTION:
Never operate other function such as pressing BACK while writing index data.
SKIB3691E
Selected pattern
: 7
Up/Down adjustment range
: 20
°
to 20
°
Left/Right adjustment range
: 20
°
to 20
°
JSNIA2231ZZ
AV
STEERING ANGLE SENSOR
AV-161
< REMOVAL AND INSTALLATION >
[BASE AUDIO WITH COLOR DISPLAY]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
STEERING ANGLE SENSOR
Exploded View
INFOID:0000000009721694
DISASSEMBLY
Removal and Installation
INFOID:0000000009721695
REMOVAL
1.
Remove spiral cable. Refer to
(except for Mexico) or
(for
Mexico).
2.
Remove steering angle sensor from spiral cable.
INSTALLATION
1.
Install in the reverse order of removal.
2.
Perform steering angle sensor neutral position adjustment. Refer to
.
JSNIA0135ZZ
1.
Spiral cable
2.
Steering angle sensor
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст