Nissan Terrano model r20 series 2004. Manual — part 242
I
Wrap a small screwdriver with vinyl tape and use it to insert the
valves into proper position.
Pressure regulator valve
I
If pressure regulator plug is not centered properly, sleeve can-
not be inserted into bore in upper body.
If this happens, use vinyl tape wrapped screwdriver to center
sleeve until it can be inserted.
I
Turn sleeve slightly while installing.
Accumulator control plug
I
Align protrusion of accumulator control sleeve with notch in
plug.
I
Align parallel pin groove in plug with parallel pin, and install
accumulator control valve.
2. Install parallel pins and retainer plates.
I
While pushing plug, install parallel pin.
SAT831A
SAT832A
SAT833A
SAT834A
SAT823A
REPAIR FOR COMPONENT PARTS
Control Valve Upper Body (Cont’d)
AT-152
4-2 sequence valve and relay valve
I
Push 4-2 sequence valve and relay valve with wire wrapped in
vinyl tape to prevent scratching valve body. Install parallel pins.
I
Insert retainer plate while pushing spring.
SAT835A
SAT836A
REPAIR FOR COMPONENT PARTS
Control Valve Upper Body (Cont’d)
AT-153
Control Valve Lower Body
Apply ATF to all components before their installation.
Numbers preceding valve springs correspond with those shown in SDS on page AT-202.
SAT112GA
REPAIR FOR COMPONENT PARTS
AT-154
DISASSEMBLY
1. Remove valves at parallel pins.
2. Remove valves at retainer plates.
For removal procedures, refer to “DISASSEMBLY” of Control
Valve Upper Body.
INSPECTION
Valve springs
I
Check each valve spring for damage or deformation. Also mea-
sure free length and outer diameter.
Inspection standard:
Refer to SDS, AT-202.
I
Replace valve springs if deformed or fatigued.
Control valves
I
Check sliding surfaces of control valves, sleeves and plugs for
damage.
ASSEMBLY
I
Install control valves.
For installation procedures, refer to “ASSEMBLY” of Control
Valve Upper Body, AT-151.
SAT838A
SAT829A
SAT838A
REPAIR FOR COMPONENT PARTS
Control Valve Lower Body (Cont’d)
AT-155
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст