Nissan Terrano model r20 series 2004. Manual — part 366
WATER COCK CONTROL ROD
I
When adjusting water cock control rod, first disconnect
temperature control cable from air mix door lever and then
adjust control rod. Reconnect temperature control cable
and readjust it. (Refer to next item.)
1. Push air mix door lever in direction of arrow.
2. Pull control rod of water cock in direction of arrow so as to make
clearance of about 2 mm (0.08 in) between ends of rod and link
lever and connect the rod to door lever.
After connecting control rod, check that it operates properly.
TEMPERATURE CONTROL CABLE
I
When adjusting ventilator door rod and defroster door rod,
first disconnect air control cable from side link.
Reconnect and readjust air control cable.
For L.H. drive model
I
Move temperature control lever to max. COLD position. Set air
mix door lever in full cold mode. Pull outer cable in direction of
arrow and then clamp it.
For R.H. drive model
I
Move temperature control lever to max. HOT position. Set air
mix door lever in full hot mode. Pull outer cable in direction of
arrow and then clamp it.
After positioning control cable, check it operates properly.
INTAKE DOOR CONTROL LINKAGE
I
Adjust the portion of connecting rod where indicated with arrow
as shown in figure.
RHA030E
RHA349I
RHA350I
NHA355
NHA356
TROUBLE DIAGNOSES
Control Linkage Adjustment (Cont’d)
HA-64
General Specifications
COMPRESSOR
Model
DKS-17CH
Type
Swash plate
Displacement
cm
3
(cu in)/Rev
168 (10.25)
Direction of rotation
Clockwise
(Viewed from drive end)
Drive belt
A type
LUBRICATION OIL
Model
ZEXEL make
DKS-17CH
Name
Nissan A/C System Oil
Type S
Part number
KLH00-PAGS0
Capacity
m
(Imp fl oz)
Total in system
TD ENGINE: 250 (8.8)
ZD ENGINE: 200 (7.0)
Compressor (Service parts)
charging amount
TD ENGINE: 250 (8.8)
ZD ENGINE: 200 (7.0)
REFRIGERANT
Type
R134a
Capacity
kg (lb)
0.60 - 0.70 (1.32 - 1.54)
Inspection and Adjustment
ENGINE IDLING SPEED
When A/C is ON
Refer to EF & EC section.
BELT TENSION
Refer to Checking Drive Belts (MA section).
COMPRESSOR
Model
DKS-17CH
Clutch disc-to-pulley clearance
mm (in)
0.3 - 0.6
(0.012 - 0.024)
SERVICE DATA AND SPECIFICATIONS (SDS)
HA-65
NOTES
STARTING & CHARGING SYSTEMS
CONTENTS
. . . . . . . . . . . . . . . ...2
Supplemental Restraint System (SRS)
. . . ...2
Wiring Diagrams and Trouble Diagnoses. . . . . 2
. . . . . . . . . . . . . . . . . . .3
How to Handle Battery . . . . . . . . . . . . 3
Battery Test and Charging Chart. . . . . . . . .6
. . . . . . . . . . . . . .13
System Description. . . . . . . . . . . . . 13
Wiring Diagram - START -. . . . . . . . . . .14
Trouble Diagnoses. . . . . . . . . . . . . .16
Construction. . . . . . . . . . . . . . . ...17
Magnetic Switch Check . . . . . . . . . . . .19
Pinion/Clutch Check . . . . . . . . . . . . ..19
Brush Check . . . . . . . . . . . . . . . ..20
Field Coil Check . . . . . . . . . . . . . . 20
Armature Check. . . . . . . . . . . . . . .21
Assembly . . . . . . . . . . . . . . . . ...22
. . . . . . . . . . . . . 23
System Description. . . . . . . . . . . . . 23
Wiring Diagram - CHARGE -. . . . . . . . . .24
Trouble Diagnoses. . . . . . . . . . . . . .26
Construction. . . . . . . . . . . . . . . ...27
Disassembly. . . . . . . . . . . . . . . ...28
Inspection. . . . . . . . . . . . . . . . ...28
Assembly . . . . . . . . . . . . . . . . ...29
SERVICE DATA AND SPECIFICATIONS (SDS)
. . ..30
Battery. . . . . . . . . . . . . . . . . . 30
Starter . . . . . . . . . . . . . . . . . . 30
Alternator . . . . . . . . . . . . . . . . ...30
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст