Nissan Terrano model r20 series 2004. Manual — part 250
d. Install band servo retainer onto transmission case.
4. Install rear side clutch and gear components.
a. Place transmission case in vertical position.
b. Slightly lift forward clutch drum assembly. Then slowly rotate it
clockwise until its hub passes fully over clutch inner race inside
transmission case.
c. Check to be sure that rotation direction of forward clutch
assembly is correct.
d. Install thrust washer onto front of overrun clutch hub.
I
Apply petroleum jelly to the thrust washer.
I
Insert pawls of thrust washer securely into holes in over-
run clutch hub.
SAT940A
NAT303
SAT944A
SAT945A
SAT946A
ASSEMBLY
Assembly (1) (Cont’d)
AT-184
e. Install overrun clutch hub onto rear internal gear assembly.
f.
Install needle bearing onto rear of overrun clutch hub.
I
Apply petroleum jelly to needle bearing.
g. Check that overrun clutch hub rotates as shown while holding
forward clutch hub.
h. Place transmission case into horizontal position.
i.
Install rear internal gear, forward clutch hub and overrun clutch
hub as a unit onto transmission case.
SAT947A
SAT948A
SAT949A
NAT304
SAT951A
ASSEMBLY
Assembly (1) (Cont’d)
AT-185
j.
Install needle bearing onto rear internal gear.
I
Apply petroleum jelly to needle bearing.
k. Install bearing race onto rear of front internal gear.
I
Apply petroleum jelly to bearing race.
I
Securely engage pawls of bearing race with holes in front
internal gear.
l.
Install front internal gear on transmission case.
5. Install output shaft and parking gear.
a. Insert output shaft from rear of transmission case while slightly
lifting front internal gear.
I
Do not force output shaft against front of transmission
case.
b. Carefully push output shaft against front of transmission case.
Install snap ring on front of output shaft.
I
Check to be sure output shaft cannot be removed in rear
direction.
SAT952A
SAT953A
SAT954A
SAT216B
SAT957A
ASSEMBLY
Assembly (1) (Cont’d)
AT-186
c. Install needle bearing on transmission case.
I
Pay attention to its direction — Black side goes to rear.
I
Apply petroleum jelly to needle bearing.
d. Install parking gear on transmission case.
e. Install snap ring on rear of output shaft.
I
Check to be sure output shaft cannot be removed in for-
ward direction.
6. Install adapter case.
a. Install oil seal on adapter case.
I
Apply ATF to oil seal.
b. Install O-ring on revolution sensor.
I
Apply ATF to O-ring.
c. Install revolution sensor on adapter case.
SAT217B
SAT218B
SAT960A
NAT305
SAT757I
ASSEMBLY
Assembly (1) (Cont’d)
AT-187
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст