Nissan Terrano model r20 series 2004. Manual — part 261
Installation
Install a new oil seal, using a suitable tool.
Rear Case
REAR OIL SEAL
Removal
Remove the oil seal. Be careful not to damage its housing. Always
replace after every disassembly.
Installation
Install a new oil seal, using the Special Tool.
AIR BREATHER
Install as shown in the illustration.
Shift Control Components
INSPECTION
I
Check contact surface and sliding surface for wear, scratches,
projections or other faulty conditions.
SMT315A
YMT025
YMT026
YTF005
SMT360A
REPAIR FOR COMPONENT PARTS
Bearing Retainer (Cont’d)
TF-24
L & H SHIFT ROD & FORK
Assemble as shown in the illustration.
*
This pin is the same size as the one for 2-4 shift rod.
2-4 SHIFT ROD & FORK
Assemble as shown in the illustration.
*
These pins are the same size.
Pay special attention to the direction of fork guide collar.
SMT319A
SMT320A
SMT321A
REPAIR FOR COMPONENT PARTS
Shift Control Components (Cont’d)
TF-25
1. Assemble front case.
a. Install main gear assembly by tapping lightly.
b. Apply sealant to the mating surface and bolts of front case
cover and install it on front case.
I
These ten bolts should be coated with sealant.
Tightening torque
q
A
: 20 - 23 N
⋅
m
(2.1 - 2.3 kg-m, 15 - 16 ft-lb)
q
B
: 24 - 28 N
⋅
m
(2.5 - 2.8 kg-m, 18 - 20 ft-lb)
c. Apply gear oil to needle bearing and install it into main gear.
d. Install counter gear assembly by tapping lightly.
e. Install cross shaft and inner shift lever.
When replacing cross shaft, outer shift lever of lock pin of
outer shift lever, replace them as a set.
SMT323A
YMT027
SMT326A
SMT327A
SMT798A
ASSEMBLY
TF-26
f.
Apply sealant to plug and install it into front case.
g. Insert interlock plunger into front case.
h. Install L & H shift rod and fork assembly with coupling sleeve.
i.
Install 2-4 shift rod.
j.
Install switches, check balls, check springs and plugs.
Apply sealant to switches and plugs.
SMT330A
SMT331A
SMT332A
SMT333A
YTF004
ASSEMBLY
TF-27
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст