Nissan Terrano model r20 series 2004. Manual — part 319
Inspection
BALL JOINT AND SWIVEL JOINT
1. Check joints for play. If ball or swivel stud is worn and play in
axial direction is excessive or joint is hard to swing or does not
meet the specified values, replace as a complete unit.
Swinging force (Measuring point: Cotter pin hole) “A”:
The ball joint must rotate smoothly in all direc-
tions.
Rotating torque “B”: (both)
0.5 - 5.0 N
⋅
m (0.05 - 0.51 kg-m, 4 - 44 in-lb)
Axial end play “C”: (both)
0 - 0.2 mm (0 - 0.008 in)
Radial play “D” (both)
0 mm (0 in)
2. Check condition of dust cover. If it is cracked excessively,
replace ball joint or swivel joint as an assembly.
I
Check rotating torque “B”.
EST015
EST016
YST025
STEERING LINKAGE
ST-20
IDLER ARM ASSEMBLY
I
Check idler arm assembly for breakage, wear or play, and if
necessary replace.
Rotating force “A”:
1 - 6 N
⋅
m (0.1 - 0.6 kg-m, 9 - 52 in-lb)
Axial end play “B”:
0 m (0 in)
Deflection “C” (when load is applied to the end of
arm):
Load
N (kg, lb)
1,569
(160, 353)
3,923 (400, 882)
Deflection
mm (in)
Max.
3 (0.12)
5.5 (0.217)
Min.
0.7 (0.028)
1.0 (0.039)
I
Lubricate idler arm assembly with recommended multipurpose
grease.
When lubricating, refer to section MA.
CROSS ROD AND TIE-ROD
Check tie-rod and cross rod for breakage, bend or cracks, and
replace with a new one if necessary.
FIXING LOCATION
I
Check fixing location (nuts and cotter pins) for looseness, play
or breakage.
I
When looseness or play is found, check for wear on tapered
portion of joints, gear arm and idler arm.
SST631B
STEERING LINKAGE
Inspection (Cont’d)
ST-21
General Specifications
Models
All
Steering gear type
ZF 8054
Turns of steering
wheel
(Lock to lock)
3.86
Overall gear ratio
17.1 : 1
Steering column type
Collapsible, adjustable height
Inspection and Adjustment
STEERING WHEEL AND COLUMN
Applied model
AIR BAG
Steering wheel axial play
mm (in)
0 (0)
Steering wheel play
mm (in)
35 (1.38) or less
Steering column length “L”
mm (in)
830.5 - 832.7
(32.697 - 32.783)
EST018
STEERING GEAR AND LINKAGE
Ball joint and swivel joint
Rotating torque “B”
N
⋅
m (kg-m, in-lb)
0.5 - 5.0
(0.05 - 0.51,
4 - 44)
Axial end play “C”
mm (in)
0 - 0.2 (0 - 0.008)
Radial play “D”
mm (in)
0 (0)
Length “L”
mm (in)
287 (11.30)
SST583B
OIL PUMP
Unit: kPa (bar, kg/cm
2
, psi)
Engine
ZD30DDTi
TD27Ti
Make
UNISIA
Max. pressure
9,800 - 10,500
(98.0 - 105.0,
99.96 - 107.10,
1,421 - 1,523)
8,800 - 9,200
(88 - 92,
89 - 93,
1,276 - 1,334)
SERVICE DATA AND SPECIFICATIONS (SDS)
ST-22
RESTRAINT SYSTEM
CONTENTS
. . . . . . . . . . . . . . . . ...2
Precautions . . . . . . . . . . . . . . . . ..2
Front Seat Belt. . . . . . . . . . . . . . . .4
Rear Seat Belt . . . . . . . . . . . . . . . .6
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
. . . 8
Precautions . . . . . . . . . . . . . . . . ..8
Preparation . . . . . . . . . . . . . . . . ..9
SRS Configuration . . . . . . . . . . . . . .10
Seat Belt Pre-tensioner with Load Limiter. . . . . 11
Built-in Type Side Air Bag. . . . . . . . . . .. 11
SRS Component Parts Location . . . . . . . ...12
Maintenance Items . . . . . . . . . . . . . 12
Diagnosis Sensor Unit . . . . . . . . . . . ...13
Front Seat Belt Pre-tensioner. . . . . . . . . 14
Side Air Bag (Satellite) Sensor. . . . . . . . ..15
Driver Air Bag Module and Spiral Cable . . . . ...16
Front Passenger Air Bag Module . . . . . . . ..19
Front Side Air Bag Module . . . . . . . . . . 20
Disposal of Air Bag Module and Seat Belt Pre-
tensioner . . . . . . . . . . . . . . . . . 22
Trouble Diagnoses Introduction. . . . . . . . .28
How to Perform Trouble Diagnoses for Quick
and Accurate Repair . . . . . . . . . . . . ..31
Schematic . . . . . . . . . . . . . . . . ..33
Wiring Diagram - SRS -. . . . . . . . . . . .34
SRS Operation Check . . . . . . . . . . . ...38
Trouble Diagnoses with CONSULT-II. . . . ..39
Trouble Diagnoses without CONSULT-II. . . .48
Does Not Turn Off . . . . . . . . . . . . . .56
Trouble Diagnoses:
Does Not Turn On . . . . . . . . . . . . . .58
Collision Diagnosis . . . . . . . . . . . . . 59
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст