Nissan Versa Sedan. Manual — part 557
PRECAUTIONS
LU-3
< PRECAUTION >
[HR16DE]
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
1. Remove the old liquid gasket adhering to the gasket application
surface and the mating surface using suitable tool.
• Remove the liquid gasket completely from the groove of the
liquid gasket application surface, bolts, and bolt holes.
2. Thoroughly clean the mating surfaces and remove adhering
moisture, grease and foreign material.
3. Attach the liquid gasket tube to the Tool.
Use Genuine RTV Silicone Sealant or equivalent. Refer to
GI-21, "Recommended Chemical Products and Sealants"
.
4. Apply the liquid gasket without breaks to the specified location
with the specified dimensions.
• If there is a groove for the liquid gasket application, apply the
liquid gasket to the groove.
• Normally apply the liquid gasket on the inside edge of the bolt
holes. Also apply to the outside edge of the bolt holes when
specified in the procedure.
• Within five minutes of liquid gasket application, install the mat-
ing component.
• If the liquid gasket protrudes, wipe it off immediately.
• Do not retighten after the installation.
• Wait 30 minutes or more after installation before refilling the
engine with oil or coolant.
CAUTION:
If there are more specific instructions in the procedures contained in this manual concerning liq-
uid gasket application, observe them.
PBIC0003E
Tool number
: WS39930000 ( — )
WBIA0567E
SEM159F
LU-4
< PREPARATION >
[HR16DE]
PREPARATION
PREPARATION
PREPARATION
Special Service Tools
INFOID:0000000009524366
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tools
INFOID:0000000009524367
Tool number
(Kent-Moore No.)
Tool name
Description
ST25051001
(J-25695-1)
Oil pressure gauge
Measuring oil pressure
Maximum measuring range: 2,452 kPa (225
kg-cm
2
, 356 psi)
ST25052000
(J-25695-2)
Hose
Adapting oil pressure gauge to cylinder block
KV10115801
(J-38956)
Oil filter wrench
Removing oil filter
a: 64.3 mm (2.531 in)
KV10111100
(J-37228)
Seal cutter
Removing steel oil pan and rear timing chain
case
WS39930000
( — )
Tube presser
Pressing the tube of liquid gasket
NT050
S-NT559
S-NT375
S-NT046
NT052
PREPARATION
LU-5
< PREPARATION >
[HR16DE]
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
Tool name
Description
Deep socket
Removing and installing oil pressure switch
27 mm (1.06 in)
Power tool
Loosening nuts, screws and bolts
PBIC4066E
PIIB1407E
LU-6
< SYSTEM DESCRIPTION >
[HR16DE]
DESCRIPTION
SYSTEM DESCRIPTION
DESCRIPTION
Engine Lubrication System
INFOID:0000000009269695
JPBIA4752GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст