Nissan Versa Sedan. Manual — part 73
BCS
BCM
BCS-53
< WIRING DIAGRAM >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
ABMIA4734GB
BCS-54
< WIRING DIAGRAM >
[WITH INTELLIGENT KEY SYSTEM]
BCM
ABMIA4735GB
BCS
BCM
BCS-55
< WIRING DIAGRAM >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
ABMIA4736GB
BCS-56
< BASIC INSPECTION >
[WITH INTELLIGENT KEY SYSTEM]
INSPECTION AND ADJUSTMENT
BASIC INSPECTION
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM)
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description
INFOID:0000000009268637
BEFORE REPLACEMENT
When replacing BCM, save or print current vehicle specification with CONSULT configuration before replace-
ment.
NOTE:
If “Before Replace ECU” cannot be used, use the “After Replace ECU” or “Manual Configuration” after replac-
ing BCM.
AFTER REPLACEMENT
CAUTION:
• When replacing BCM, you must perform “After Replace ECU” with CONSULT.
- Complete the procedure of “After Replace ECU” in order.
- If you set incorrect “After Replace ECU”, incidents might occur.
- Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
• When replacing BCM, perform the system initialization (NATS).
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Proce-
dure
INFOID:0000000009268638
1.
SAVING VEHICLE SPECIFICATION
CONSULT
Enter "Re/Programming, Configuration" and perform “Before Replace ECU” to save or print current vehicle
specification.
NOTE:
If “Before Replace ECU” cannot be used, use the "After Replace ECU" or "Manual Configuration" after replac-
ing BCM.
>> GO TO 2.
2.
REPLACE BCM
Replace BCM. Refer to
BCS-69, "Removal and Installation"
>> GO TO 3.
3.
WRITING VEHICLE SPECIFICATION
CONSULT
1. Enter "Re/Programming, Configuration".
2. If “Before Replace ECU” operation was performed, automatically an "Operation Log Selection" screen will
be displayed. Select the applicable file from the "Saved Data List" and press “Confirm” to write vehicle
specification. Refer to
BCS-56, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) :
3. If “Before Replace ECU” operation was not performed, select "After Replace ECU" or "Manual Configura-
tion" to write vehicle specification. Refer to
BCS-56, "ADDITIONAL SERVICE WHEN REPLACING CON-
TROL UNIT (BCM) : Work Procedure"
.
>> GO TO 4.
4.
INITIALIZE BCM (NATS)
Perform BCM initialization. (NATS)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст