Nissan Almera Tino V10 (2001 year). Manual — part 126
Fig. 6
NLEL0504S1306
YEL460C
POWER DOOR LOCK
Wiring Diagram — D/LOCK —/LHD Models (Cont’d)
EL-271
Trouble Diagnoses/LHD Models
NLEL0505
SYMPTOM CHART
NLEL0505S02
REFERENCE PAGE (EL-
)
SYMPTOM
Main
power
supply
and
ground
circuit
check
Door
lock/unlock
switch
check
Door
key
cylinder
switch
check
Door
lock
actuator
check
Door
switch
check
Door
unlock
sensor
check
Key
switch
check
1
Power door lock does not operate using any
switch.
X
X
2
Power door lock does not operate with lock/
unlock switch.
X
3
Power door lock does not operate with door key
cylinder switch.
X
4
Specific door lock actuator does not operate.
X
5
*Key reminder system does not operate.
X
X
X
X: Applicable
*: Make sure the power door lock system operates properly.
POWER DOOR LOCK
Trouble Diagnoses/LHD Models
EL-272
MAIN POWER SUPPLY AND GROUND CIRCUIT CHECK
=NLEL0505S03
Main Power Supply Circuit Check
NLEL0505S0301
NEL672
Ground Circuit Check
NLEL0505S0302
NEL666
POWER DOOR LOCK
Trouble Diagnoses/LHD Models (Cont’d)
EL-273
DOOR LOCK/UNLOCK SWITCH CHECK
=NLEL0505S04
1
CHECK DOOR LOCK/UNLOCK SWITCH INPUT SIGNAL
1. Disconnect time control unit harness connector.
2. Check continuity between time control unit harness connector terminal 37 or 38 and ground.
NEL674
Refer to wiring diagram.
OK or NG
OK
©
Door lock/unlock switch is OK.
NG
©
GO TO 2.
2
CHECK DOOR LOCK/UNLOCK SWITCH
1. Disconnect door lock/unlock switch harness connector.
2. Check continuity between each door lock/unlock switch terminals.
+
Power window main switch (Door lock/unlock switch)
NEL675
OK or NG
OK
©
Check the following.
+
Ground circuit for door lock/unlock switch
+
Harness for open or short between door lock/unlock switch and time control unit con-
nector
NG
©
Replace door lock/unlock switch.
POWER DOOR LOCK
Trouble Diagnoses/LHD Models (Cont’d)
EL-274
DOOR KEY CYLINDER SWITCH CHECK
NLEL0505S05
1
CHECK DOOR KEY CYLINDER SWITCH INPUT SIGNAL (LOCK/UNLOCK SIGNAL)
Check voltage between time control unit harness connector terminals 28 or 29 and ground.
NEL676
Refer to wiring diagram.
OK or NG
OK
©
Door key cylinder switch is OK.
NG
©
GO TO 2.
2
CHECK DOOR KEY CYLINDER SWITCH
1. Disconnect door key cylinder switch harness connector.
2. Check continuity between door key cylinder switch terminals.
NEL677
OK or NG
OK
©
Check the following.
+
Door key cylinder switch ground circuit
+
Harness for open or short between time control unit and door key cylinder switch
NG
©
Replace door key cylinder switch.
POWER DOOR LOCK
Trouble Diagnoses/LHD Models (Cont’d)
EL-275
DOOR LOCK ACTUATOR CHECK
NLEL0505S06
1
CHECK DOOR LOCK ACTUATOR OUTPUT SIGNAL
Check voltage for door lock actuator.
+
Door lock actuator driver’s side
NEL678
+
Door lock actuator passenger side and rear
NEL679
Refer to wiring diagram.
OK or NG
OK
©
GO TO 2.
NG
©
Replace time control unit. (Before replacing the control unit, perform “DOOR LOCK/
UNLOCK SWITCH CHECK”.)
POWER DOOR LOCK
Trouble Diagnoses/LHD Models (Cont’d)
EL-276
2
CHECK DOOR LOCK ACTUATOR
1. Disconnect door lock actuator harness connector.
2. Apply 12V direct current to door lock actuator and check operation.
+
Front and rear door
NEL680
+
Back door
NEL681
OK or NG
OK
©
Check harness for open or short between time control unit connector and door lock
actuator.
NG
©
Replace door lock actuator.
DOOR SWITCH CHECK
NLEL0505S08
1
CHECK DOOR SWITCH INPUT SIGNAL
Check voltage between time control unit harness connector terminals 6 and ground.
NEL647
Refer to wiring diagram.
OK or NG
OK
©
Door switch is OK.
NG
©
GO TO 2.
POWER DOOR LOCK
Trouble Diagnoses/LHD Models (Cont’d)
EL-277
2
CHECK DOOR SWITCH
1. Disconnect door switch harness connector.
2. Check continuity between door switch terminals.
NEL648
OK or NG
OK
©
Check the following.
+
Door switch ground circuit or door switch ground condition
+
Harness for open or short between smart entrance control unit and door switch
NG
©
Replace door switch.
DOOR UNLOCK SENSOR CHECK
NLEL0505S09
1
CHECK DOOR UNLOCK SENSOR INPUT SIGNAL
Check voltage between time control unit terminal 35 or 36 and ground.
NEL682
Refer to wiring diagram.
OK or NG
OK
©
Door unlock sensor is OK.
NG
©
GO TO 2.
POWER DOOR LOCK
Trouble Diagnoses/LHD Models (Cont’d)
EL-278
2
CHECK DOOR UNLOCK SENSOR
1. Disconnect door unlock sensor connector.
2. Check continuity between door unlock sensor terminals 2 and 4.
NEL683
OK or NG
OK
©
Check the following.
+
Door unlock sensor ground circuit
+
Harness for open or short between time control unit and door unlock sensor
NG
©
Replace door unlock sensor.
KEY SWITCH (INSERT) CHECK
NLEL0505S11
1
CHECK KEY SWITCH INPUT SIGNAL
Check voltage between time control unit terminal 22 and ground.
NEL653
Refer to wiring diagram.
OK or NG
OK
©
Key switch is OK.
NG
©
GO TO 2.
POWER DOOR LOCK
Trouble Diagnoses/LHD Models (Cont’d)
EL-279
2
CHECK KEY SWITCH (INSERT)
Check continuity between key switch terminals 1 and 2.
NEL787
OK or NG
OK
©
Check the following.
+
10A fuse [No. 12, located in fuse block (J/B)]
+
Harness for open or short between key switch and fuse
+
Harness for open or short between time control unit and key switch
NG
©
Replace key switch.
POWER DOOR LOCK
Trouble Diagnoses/LHD Models (Cont’d)
EL-280
System Description/RHD Models
NLEL0395
OUTLINE
NLEL0395S01
Power door lock system with super lock and key reminder is controlled by time control unit. Super lock has a
higher anti-theft performance than conventional power door lock systems.
When super lock is in released condition, lock knob operation locks or unlocks door.
When super lock is in set condition, lock knob operation cannot lock nor unlock door.
SEL831U
OPERATION
NLEL0395S02
Power door lock/unlock and super lock set/release operation by door key cylinder
+
With the key inserted into front door key cylinder, turning it to LOCK will lock all doors and set super lock.
(Super lock will not be set while key is inserted in the ignition key cylinder.)
+
With the key inserted into front door key cylinder, turning it to UNLOCK will unlock all doors and release
super lock.
Power door lock/unlock and super lock set/release operation by multi-remote controller (If equipped)
+
Pressing multi-remote controller LOCK button will lock all doors and set super lock. (Super lock will not be
set while key is inserted in the ignition key cylinder.)
+
Pressing multi-remote controller UNLOCK button once will unlock driver door and release super lock. Then,
if an unlock signal is sent from the remote controller again within 5 seconds, all other doors will be
unlocked.
Power door lock and super lock release operation (by NATS IMMU signal)
+
When the super lock is set, turning the ignition key switch to ON will release the super lock. All doors will
unlock once, but then immediately lock again.
Power door lock/unlock operation by lock/unlock switch
+
With lock/unlock switch on driver door trim setting to LOCK will lock all doors.
+
With lock/unlock switch on driver door trim setting to UNLOCK will unlock all doors.
Lock/unlock switch operation cannot control super lock.
Key reminder system
+
If the ignition key is in the ignition key cylinder and driver door is open, setting lock/unlock switch, lock
POWER DOOR LOCK — SUPER LOCK —
System Description/RHD Models
EL-281
knob, key or multi-remote controller to “LOCK” locks the door once but then immediately unlocks all doors.
(signal from door unlock sensor driver side)
System initialization
+
System initialization is required when battery cables are reconnected. Conduct the following to release
super lock once;
— insert the key into the ignition key cylinder and turn it to ON.
— LOCK/UNLOCK operation using door key cylinder or multi-remote controller.
POWER DOOR LOCK — SUPER LOCK —
System Description/RHD Models (Cont’d)
EL-282
NOTE:
POWER DOOR LOCK — SUPER LOCK —
System Description/RHD Models (Cont’d)
EL-283
Schematic/RHD Models
NLEL0475
YEL461C
POWER DOOR LOCK — SUPER LOCK —
Schematic/RHD Models
EL-284
YEL462C
POWER DOOR LOCK — SUPER LOCK —
Schematic/RHD Models (Cont’d)
EL-285
Wiring Diagram — S/LOCK —/RHD Models
NLEL0476
MODELS WITH FUSE AND FUSIBLE LINK BOX E43
NLEL0476S10
Fig. 1
NLEL0476S1001
YEL941B
POWER DOOR LOCK — SUPER LOCK —
Wiring Diagram — S/LOCK —/RHD Models
EL-286
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст