Nissan Primera P11. Manual — part 550
CAUTION:
●
The rotation of the spiral cable (SRS “Air bag” component
part) is limited. If the steering gear must be removed, set
the front wheels in the straight-ahead direction. Do not
rotate the steering column while the steering gear is
removed.
●
Remove the steering wheel before removing the steering
lower joint to avoid damaging the SRS spiral cable.
NST019
Upper column cover
Steering column
assembly
Ignition switch grommet
Lower column cover
13 - 18
(1.3 - 1.8, 9 - 13)
15 - 19
(1.5 - 1.9, 11 - 14)
Push-on nut
: N·m (kg-m, ft-lb)
SEC. 484
⋅
487
⋅
488
Spiral cable
Steering wheel
29 - 39
(3.0 - 4.0,
22 - 29)
Horn pad (Includ-
ing Airbag mod-
ule)
STEERING WHEEL AND STEERING COLUMN
ST-9
Removal and Installation
STEERING WHEEL
●
Remove screws from both sides of steering wheel and pull
out horn pad. Refer to RS section for Air Bag Module and
Spiral Cable Removal.
●
Align spiral cable correctly when installing steering wheel.
Refer to RS-section.
STEERING COLUMN
●
When installing steering column, fingertighten all lower
bracket and clamp retaining bolts; then tighten them
securely. Do not apply undue stress to steering column.
●
When attaching coupling joint, be sure tightening bolt faces
cutout portion.
●
Align slit of lower joint with projection on dust cover. Insert
joint until surface A contacts surface B.
CAUTION:
After installing steering column, turn steering wheel to make
sure it moves smoothly and that the number of turns from
the straight forward position to left and right locks are equal.
Be sure that the steering wheel is in a neutral position when
driving straight ahead.
NBF004
NST003
SST491C
Steering gear
STEERING WHEEL AND STEERING COLUMN
ST-10
Disassembly and Assembly
WARNING:
Refer to ‘PRECAUTIONS” (on page ST-2) and to RS section
for spiral cable servicing information.
●
To remove combination switch, remove attaching screws,
disconnect harnesses and remove switch.
NST020
Boot
Combination
switch assembly
24 - 29
(2.4 - 3.0,
17 - 22)
Jacket tube assembly
Washer
Spiral cable assy
: N·m (kg-m, ft-lb)
: Do not re-use
SEC. 488
O-ring
Snap ring
24 - 29
(2.4 - 3.0, 17 - 22)
Lower joint
Column shaft assembly
NST021
Screws remain captive in switch
Remove
STEERING WHEEL AND STEERING COLUMN
ST-11
●
Ensure that rounded surface of snap ring faces toward bear-
ing when snap ring is installed.
●
Install snap ring on upper shaft with a suitable tool.
●
Steering lock
a. Break self-shear type screws with a drill or other appropriate
tool.
b. Install self-shear type screws and then cut off self-shear type
screw heads.
Inspection
Tilt mechanism
●
After installing steering column, check tilt mechanism opera-
tion.
SST770A
SST741A
SST742A
SST582B
STEERING WHEEL AND STEERING COLUMN
Disassembly and Assembly (Cont’d)
ST-12
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст