Nissan Primera P11. Manual — part 458
Function and System Application
Diagnostic
test mode
Function
ENGINE
H
⋅
CVT
ABS
AIR
BAG
NATS
Work support
This mode enables a technician to adjust some devices faster
and more accurate by following the indications on CONSULT-II.
×
—
—
—
—
Self-diagnostic
results
Self-diagnostic results can be read and erased quickly.
×
x
x
×
×
Trouble diagnostic
record
Current self-diagnostic results and all trouble diagnostic records
previously stored can be read.
—
—
—
x
—
ECU discriminated
No.
Classification number of a replacement ECU can be read to pre-
vent an incorrect ECU from being installed.
—
—
—
×
—
Data monitor
Input/Output data in the ECM can be read.
×
x
x
—
—
DTC work support
This mode enables a technician to set operating conditions to
confirm self-diagnosis status/results.
x
x
—
—
—
Active test
Diagnostic Test Mode in which CONSULT-II drives some actua-
tors apart from the ECMs and also shifts some parameters in a
specified range.
×
—
x
—
—
ECM part number
ECM part number can be read.
×
x
x
—
—
Control unit initialisa-
tion
All registered ignition key IDs in NATS components can be initia-
lised and new IDs can be registered.
—
—
—
—
x
DTC & SRT confirma-
tion
The results of SRT (System Readiness Test) and the self-diag-
nosis status/results can be confirmed.
x
—
—
—
—
×
: Applicable
*1: NATS: Nissan Anti-Theft System
Nickel Metal Hydride Battery Replacement
CONSULT-II contains a nickel metal hydride battery. When replacing the battery obey the following:
WARNING:
Replace the nickel metal hydride battery with genuine CONSULT-II battery only. Use of another bat-
tery may present a risk of fire or explosion. The battery may present a fire or chemical burn hazard
if mistreated. Do not recharge, disassemble of dispose of in fire.
Keep the battery out of reach of children and discard used battery conforming to the local regula-
tions.
Checking Equipment
When ordering the equipment below, contact your NISSAN distributor.
Tool name
Description
NISSAN CONSULT-II
p
1
CONSULT-II unit
and accessories
p
2
Program card
AED00B-1 and
AEN00A (for NATS)
Refer to the CONSULT-II
operation manual to confirm
the best combination of the
tester internal software and
the software mentioned
above.
NGI045
p
1
p
2
CONSULT-II CHECKING SYSTEM
GI-39
NOTE:
●
The CONSULT-II must be used in conjunction with a program card.
CONSULT-II does not require loading (Initialisation) procedure.
●
Be sure the CONSULT-II is turned off before installing or removing a program card.
CONSULT-II Data Link Connector (DLC)
Circuit
INSPECTION PROCEDURE
If the CONSULT-II cannot diagnose the system properly, check the following items.
Symptom
Check item
CONSULT-II cannot access
any system.
●
CONSULT-II DLC power supply circuit (Terminal 9) and ground circuit (Terminal 13)
(For detailed circuit, refer to “MIL & Data Link Connectors Wiring Diagram” in EC section.)
●
CONSULT-II DDL cable
CONSULT-II cannot access
individual system. (Other
systems can be accessed.)
●
CONSULT-II program card (Check the appropriate CONSULT-II program card for the sys-
tem.)
●
Power supply and ground circuit for the control unit of the system
(For detailed circuit, refer to wiring diagram for each system.)
●
Open or short circuit between the system and CONSULT-II DLC
(For detailed circuit, refer to wiring diagram for each system.)
SGI084A
Example
IGNITION SWITCH
ON or START
DATA LINK CONNECTOR
(DLC-II FOR CONSULT-II
AND GST)
ECM
AIR BAG DIAG-
NOSIS SENSOR
UNIT
To each diagnosed system
: DDL2 communication line (J1962)
CONSULT-II CHECKING SYSTEM
Checking Equipment (Cont’d)
GI-40
Model Variation
Body
Engine
Transaxle
Grade
RHD
LHD
4 Door
QG16DE
RS5F70A
Low
BDGARBF-EEA
BDGALBF-EGA
High
BDGARUF-EEA
BDGALUF-EGA
QG18DE
RS5F70A
Low
BATARBF-EEA
BATALBF-EGA
High
BATARUF-EEA
BATALUF-EGA
SR20DE
RS5F70A
Low
BBYARBF-EEA
BBYALBF-EGA
High
BBYARUF-EEA
BBYALUF-EGA
RE0F06A
Low
BBYARBZ-EEA
BBYALBZ-EGA
High
BBYARUZ-EEA
BBYALUZ-EGA
RE0F06A (M6)
High
BBYARUW-EEA
BBYALUW-EGA
CD20T
RS5F32A
Low
BVCARBF-TEA
BVCALBF-TGA
High
BVCARUF-TEA
BVCALUF-TGA
5 Door
QG16DE
RS5F70A
Low
FDGARBF-EEA
FDGALBF-EGA
High
FDGARUF-EEA
FDGALUF-EGA
QG18DE
RS5F70A
Low
FATARBF-EEA
FATALBF-EGA
High
FATARUF-EEA
FATALUF-EGA
SR20DE
RS5F70A
Low
FBYARBF-EEA
FBYALBF-EGA
High
FBYARUF-EEA
FBYALUF-EGA
RE0F06A
Low
FBYARBZ-EEA
FBYALBZ-EGA
High
FBYARUZ-EEA
FBYALUZ-EGA
RE0F06A (M6)
High
FBYARUW-EEA
FBYALUW-EGA
CD20T
RS5F32A
Low
FVCARBF-TEA
FVCALBF-TGA
High
FVCARUF-TEA
FVCALUF-TGA
WAGON
QG18DE
RS5F70A
Low
TATARBF-EEA
TATALBF-EGA
High
TATARUF-EEA
TATALUF-EGA
SR20DE
RS5F70A
Low
TBYARBF-EEA
TBYALBF-EGA
High
TBYARUF-EEA
TBYALUF-EGA
RE0F06A
Low
TBYARBZ-EEA
TBYALBZ-EGA
High
TBYARUZ-EEA
TBYALUZ-EGA
RE0F06A (M6)
High
TBYARUW-EEA
TBYALUW-EGA
CD20T
RS5F32A
Low
TVCARBF-TEA
TVCALBF-TGA
High
TVCARUF-TEA
TVCALUF-TGA
IDENTIFICATION INFORMATION
GI-41
Prefix and suffix designations:
B
DG
A
L
B
F
P11
E
G
A
A: Standard
E: RHD models
G: LHD models
E: EGI
T: Turbo (CD20T)
Model
F: 5-speed manual transaxle
Z: H-CVT
W: H-CVT (M6)
B: LOW
U: HIGH
L: Left-hand drive
R: Right-hand drive
A: 2-wheel drive models
DG: QG16DE engine
AT: QG18DE engine
BY: SR20DE engine
VC: CD20T engine
B: 4-door Sedan
F: 5-door Hatchback
T: Wagon
IDENTIFICATION INFORMATION
Model Variation (Cont’d)
GI-42
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст