Nissan Note E12. Manual — part 317
SQUEAK AND RATTLE TROUBLE DIAGNOSES
EXT-13
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
Diagnostic Worksheet
INFOID:0000000009671263
LAIA0072E
EXT-14
< SYMPTOM DIAGNOSIS >
SQUEAK AND RATTLE TROUBLE DIAGNOSES
LAIA0071E
FRONT BUMPER
EXT-15
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
REMOVAL AND INSTALLATION
FRONT BUMPER
Exploded View
INFOID:0000000009015848
1.
Front bumper fascia side bracket
(RH)
2.
Front bumper reinforcement
3.
Front energy absorber
4.
Front fascia side deflector (RH)
5.
Front fog lamp (RH) (if equipped) 6.
Tow cover
7.
Front license plate bracket
8.
Front bumper fascia
9.
Front fog lamp (LH) (if equipped)
10. Front fascia side deflector (LH)
11. Front under cover
12. Front bumper fascia side bracket
(LH)
13. Front bumper reinforcement
bracket (RH)
14. Front bumper reinforcement
bracket (LH)
A.
J nut
B.
Front fog lamp bracket
Pawl
AWKIA2583ZZ
EXT-16
< REMOVAL AND INSTALLATION >
FRONT BUMPER
Removal and Installation
INFOID:0000000009015849
CAUTION:
Bumper fascia is made of resin. Use care when handling to prevent damage. Avoid contact with oily
substances.
REMOVAL
1. Remove the front grille. Refer to
EXT-21, "Removal and Installation"
2. Remove the four front bumper fascia upper clips.
3. Remove the front under cover. Refer to
EXT-25, "FRONT UNDER COVER : Removal and Installation"
.
4. Partially remove front fender protectors (LH/RH) at the front edge to access front bumper fascia bolts.
5. Remove front bumper fascia bolts (A) (LH/RH).
6. Remove the front bumper fascia from the front bumper fascia
side brackets (LH/RH) by releasing the pawls as shown.
: Pawl
CAUTION:
When removing front bumper fascia, two people are
required to avoid damaging.
7. Disconnect the harness connectors from the front fog lamps (LH/RH) (if equipped).
8. Remove front bumper fascia.
9. Remove the following parts after removing front bumper fascia (if necessary).
• Tow cover
• Front fog lamps (LH/RH) (if equipped). Refer to
EXL-110, "Removal and Installation"
• Front license plate bracket
10. Remove the front energy absorber (if necessary).
11. Remove nuts and front bumper reinforcement (if necessary).
INSTALLATION
Installation is in the reverse order of removal.
Tighten the front bumper reinforcement nuts to specification (if removed). Refer to
NOTE:
• The following table shows the specified values for checking normal installation specifications.
• Fitting adjustment cannot be performed.
JMKIA8017ZZ
AWKIA1890ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст