Nissan Note E12. Manual — part 486
PCS
PUSH-BUTTON IGNITION SWITCH
PCS-71
< DTC/CIRCUIT DIAGNOSIS >
[POWER DISTRIBUTION SYSTEM]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
NO
>> Replace push-button ignition switch. Refer to
PCS-72
< SYMPTOM DIAGNOSIS >
[POWER DISTRIBUTION SYSTEM]
PUSH-BUTTON IGNITION SWITCH DOES NOT OPERATE
SYMPTOM DIAGNOSIS
PUSH-BUTTON IGNITION SWITCH DOES NOT OPERATE
Description
INFOID:0000000009567621
Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check
each symptom.
NOTE:
The engine start function, door lock function, power distribution system, and NATS-IVIS/NVIS in the Intelligent
Key system are closely related to each other regarding control. The vehicle security function can operate only
when the door lock and power distribution system are operating normally.
Conditions of Vehicle (Operating Conditions)
• “ENGINE START BY I-KEY” in “WORK SUPPORT” is ON when setting on CONSULT.
• One or more of Intelligent Keys with registered Intelligent Key ID is in the vehicle.
Diagnosis Procedure
INFOID:0000000009567622
1.
PERFORM WORK SUPPORT
Perform INSIDE ANT DIAGNOSIS in Work Support of INTELLIGENT KEY.
PCS-37, "INTELLIGENT KEY : CONSULT Function (BCM - INTELLIGENT KEY)"
>> GO TO 2.
2.
PERFORM SELF-DIAGNOSIS RESULT
Perform Self Diagnostic Result of BCM.
Is any DTCs displayed?
YES
>> Refer to
NO
>> GO TO 3.
3.
CHECK PUSH-BUTTON IGNITION SWITCH
Check push-button ignition switch.
PCS-69, "Component Function Check"
Is the operation normal?
YES
>> GO TO 4.
NO
>> Repair or replace malfunctioning parts.
4.
CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection normal?
YES
>> Refer to
GI-41, "Intermittent Incident"
.
NO
>> GO TO 1.
PCS
BCM (BODY CONTROL MODULE)
PCS-73
< REMOVAL AND INSTALLATION >
[POWER DISTRIBUTION SYSTEM]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
REMOVAL AND INSTALLATION
BCM (BODY CONTROL MODULE)
Removal and Installation
INFOID:0000000009607422
For removal and installation of the BCM (Body Control Module), refer to
BCS-67, "Removal and Installation"
.
PCS-74
< REMOVAL AND INSTALLATION >
[POWER DISTRIBUTION SYSTEM]
PUSH-BUTTON IGNITION SWITCH
PUSH-BUTTON IGNITION SWITCH
Removal and Installation
INFOID:0000000009607424
REMOVAL
1. Remove NATS antenna amp. Refer to
SEC-121, "Removal and Installation"
2. Release pawls and remove the push-button ignition switch (1).
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
ALKIA3180ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст