Nissan Pathfinder. Manual — part 988
SUNSHADE
RF-57
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
SUNSHADE
FRONT MOONROOF
FRONT MOONROOF : Removal and Installation
INFOID:0000000009176319
REMOVAL
1. Remove moonroof unit assembly. Refer to
RF-55, "Removal and Installation"
.
2. Remove glass lid. Refer to
RF-49, "Removal and Installation"
3. Remove the sunshade stoppers (1) (LH/RH) from the moonroof
unit assembly side rails (2).
: Front
4. Slide sunshade rearward past moonroof unit assembly side rail
ends to remove.
INSTALLATION
1. Move moonroof motor assembly laterally little by little so that the gear is completely engaged into the wire
on the moonroof unit assembly, and the mounting surfaces become parallel. Install the moonroof motor
assembly screws and tighten.
CAUTION:
Before installing the motor, be sure to place the link and wire assembly in the symmetrical and
fully closed position.
NOTE:
If necessary, insert a suitable tool into the drive key and rotate right or left slightly to assist in complete
moonroof motor gear alignment.
2. Remainder of installation is in the reverse order of removal.
3. Synchronize moonroof motor assembly with moonroof unit assembly. Refer to
.
REAR SUNSHADE UNIT
LIIA2347E
RF-58
< REMOVAL AND INSTALLATION >
SUNSHADE
REAR SUNSHADE UNIT : Removal and Installation
INFOID:0000000009176320
REMOVAL
1. Remove the headlining. Refer to
INT-27, "Removal and Installation"
.
2. Disconnect the harness connector from the sunshade motor assembly.
3. Remove the nuts that retain the rear sunshade unit.
4. Slide rear sunshade unit (2) rearward and remove through the
back door opening (1).
INSTALLATION
Installation is in the reverse order of removal.
1.
Rear sunshade unit
2.
Rear sunshade
3.
Locator pin
4.
Sunshade motor assembly
5.
Nut locations
A.
Nut
Front
ALKIA2393ZZ
ALKIA2914ZZ
SUNSHADE MOTOR ASSEMBLY
RF-59
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
SUNSHADE MOTOR ASSEMBLY
REAR SUNSHADE UNIT
REAR SUNSHADE UNIT : Removal and Installation
INFOID:0000000009176321
REMOVAL
1. Remove the headlining. Refer to.
INT-27, "Removal and Installation"
.
2. Disconnect the harness connector (B) from the sunshade motor
assembly (2).
: Front
3. Remove sunshade motor assembly screws (A).
4. Remove the sunshade motor assembly (2) from the rear sun-
shade unit (1).
INSTALLATION
Installation is in the reverse order of removal.
ALKIA2395ZZ
RF-60
< REMOVAL AND INSTALLATION >
WIND DEFLECTOR
WIND DEFLECTOR
Removal and Installation
INFOID:0000000009176322
REMOVAL
1. Open the glass lid to view the wind deflector installation point on the moonroof slide rail.
2. Remove two screws then remove the wind deflector link base.
3. Rotate wind deflector, then remove the spring from wind deflec-
tor spring base.
INSTALLATION
Installation is in the reverse order of removal.
JMKIA6154ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст