Nissan Pathfinder. Manual — part 426
EC-10
< PRECAUTION >
[VQ35DE]
PRECAUTIONS
• After performing each TROUBLE DIAGNOSIS, perform DTC
Confirmation Procedure or Component Function Check.
The DTC should not be displayed in the DTC Confirmation
Procedure if the repair is completed. The Component Func-
tion Check should be a good result if the repair is completed.
• When measuring ECM signals with a circuit tester, never allow
the two tester probes to contact.
Accidental contact of probes will cause a short circuit and
damage the ECM power transistor.
• B1 indicates bank 1, B2 indicates bank 2 as shown in the fig-
ure.
• Never operate fuel pump when there is no fuel in lines.
• Tighten fuel hose clamps to the specified torque.
JSBIA1315ZZ
SEF348N
SEC893C
PRECAUTIONS
EC-11
< PRECAUTION >
[VQ35DE]
C
D
E
F
G
H
I
J
K
L
M
A
EC
N
P
O
• Never depress accelerator pedal when starting.
• Immediately after starting, never rev up engine unnecessarily.
• Never rev up engine just prior to shutdown.
• When installing C.B. ham radio or a mobile phone, be sure to
observe the following as it may adversely affect electronic
control systems depending on installation location.
- Keep the antenna as far as possible from the electronic con-
trol units.
- Keep the antenna feeder line more than 20 cm (8 in) away
from the harness of electronic controls.
Never let them run parallel for a long distance.
- Adjust the antenna and feeder line so that the standing-wave
ratio can be kept smaller.
- Be sure to ground the radio to vehicle body.
SEF709Y
SEF708Y
EC-12
< PREPARATION >
[VQ35DE]
PREPARATION
PREPARATION
PREPARATION
Special Service Tools
INFOID:0000000009178000
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tools
INFOID:0000000009178001
Tool number
(Kent-Moore No.)
Tool name
Description
(J-44321)
Fuel pressure gauge
kit
Checks fuel pressure
(J-44321-6)
Fuel pressure adapter
Connects fuel pressure gauge to quick connector
type fuel lines
LEC642
LBIA0376E
Tool name
(Kent-Moore No.)
Description
(J-45488)
Quick connector re-
lease
Removes fuel tube quick connectors in engine
room
Leak detector
i.e.: (J-41416)
Locates the EVAP leakage
EVAP service port
adapter
i.e.: (J-41413-OBD)
Applies positive pressure through EVAP service
port
PBIC0198E
S-NT703
S-NT704
PREPARATION
EC-13
< PREPARATION >
[VQ35DE]
C
D
E
F
G
H
I
J
K
L
M
A
EC
N
P
O
Fuel filler cap adapter
i.e.: (MLR-8382)
Checks fuel tank vacuum relief valve opening
pressure
Socket wrench
Removes and installs engine coolant temperature
sensor. Refer to
Tool name
(Kent-Moore No.)
Description
S-NT815
S-NT705
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст