Nissan Pathfinder. Manual — part 1078
SEAT BELT PRE-TENSIONER
SR-29
< REMOVAL AND INSTALLATION >
C
D
E
F
G
I
J
K
L
M
A
B
SR
N
O
P
SEAT BELT PRE-TENSIONER
Removal and Installation
INFOID:0000000009176947
The front seat belt has two pre-tensioners. One pre-tensioner is part of the seat belt retractor and the other is
a lap belt pre-tensioner. For removal and installation, refer to
(seat belt retractor and
lap belt pretensioner)
SR-30
< REMOVAL AND INSTALLATION >
FRONT SEAT BELT BUCKLE SWITCH
FRONT SEAT BELT BUCKLE SWITCH
Removal and Installation
INFOID:0000000009176948
The front seat belt buckle switch is part of the front seat belt buckle. For removal and installation of the front
seat belt buckle, refer to
OCCUPANT CLASSIFICATION SYSTEM
SR-31
< REMOVAL AND INSTALLATION >
C
D
E
F
G
I
J
K
L
M
A
B
SR
N
O
P
OCCUPANT CLASSIFICATION SYSTEM
Removal and Installation
INFOID:0000000009176949
OCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT
WARNING:
• Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals then wait at
least three minutes.
• Do not use air tools or electric tools for servicing.
Removal
1. Remove front passenger seat assembly. Refer to
SE-86, "Removal and Installation"
2. Disconnect the harness connector from the occupant classification system control unit.
3. Remove occupant classification system control unit bolts.
4. Remove occupant classification system control unit.
CAUTION:
• Replace the occupant classification control unit if it has been dropped or sustained an impact.
• Do not strike the occupant classification control unit.
Installation
Installation is in the reverse order of removal.
CAUTION:
• Do not damage the harness connector during installation.
• After installation is complete, check that no system malfunction is detected causing the air bag
warning lamp to illuminate.
• If a malfunction is indicated by the air bag warning lamp after repair or replacement of the malfunc-
tioning parts, perform the SRS final check. Refer to
OCCUPANT CLASSIFICATION SYSTEM SENSORS
The occupant classification system sensors are part of the front passenger seat frame assembly. For removal
and installation of the front passenger seat frame assembly, refer to
.
SR-32
< REMOVAL AND INSTALLATION >
FRONT PASSENGER AIR BAG OFF INDICATOR
FRONT PASSENGER AIR BAG OFF INDICATOR
Removal and Installation
INFOID:0000000009176950
REMOVAL
1. Remove cluster lid C. Refer to
IP-22, "CLUSTER LID C : Removal and Installation"
2. Remove screws and the front passenger air bag off indicator from cluster lid C.
INSTALLATION
Installation is in the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст