Nissan Pathfinder. Manual — part 870
MWI-52
< BASIC INSPECTION >
DIAGNOSIS AND REPAIR WORK FLOW
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work flow
INFOID:0000000009174248
OVERALL SEQUENCE
DETAILED FLOW
1.
OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the conditions and environment under
which the malfunction occurred.
>> GO TO 2.
2.
CHECK SYMPTOM
• Check the symptom based on the information obtained from the customer.
• Check if any other malfunctions are present.
>> GO TO 3.
3.
CHECK CONSULT SELF-DIAGNOSIS RESULTS
Connect CONSULT and perform self-diagnosis. Refer to
.
AWNIA2375GB
MWI
DIAGNOSIS AND REPAIR WORK FLOW
MWI-53
< BASIC INSPECTION >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
Are self-diagnosis results normal?
YES
>> GO TO 4.
NO
>> GO TO 5.
4.
NARROW DOWN MALFUNCTIONING PARTS BY SYMPTOM DIAGNOSIS
Perform symptom diagnosis and narrow down the malfunctioning parts.
>> GO TO 5.
5.
REPAIR OR REPLACE MALFUNCTIONING PARTS
Repair or replace malfunctioning parts.
NOTE:
If DTC is displayed, erase DTC after repairing or replacing malfunctioning parts.
>> GO TO 6.
6.
FINAL CHECK
Check that the warning buzzer in the combination meter operates normally.
Does it operate normally?
YES
>> Inspection End.
NO
>> GO TO 1.
MWI-54
< DTC/CIRCUIT DIAGNOSIS >
U1000 CAN COMM CIRCUIT
DTC/CIRCUIT DIAGNOSIS
U1000 CAN COMM CIRCUIT
DTC Logic
INFOID:0000000009174249
DTC DETECTION LOGIC
Diagnosis Procedure
INFOID:0000000009174250
1.
CHECK CAN COMMUNICATION
Select Self-Diagnosis Results mode for METER/M&A with CONSULT.
>> GO TO LAN system. Refer to
LAN-20, "Trouble Diagnosis Flow Chart"
DTC
CONSULT Display
Detection Condition
Possible Cause
U1000
CAN COMM CIRC
[U1000]
When combination meter is not receiving CAN communication sig-
nals for 2 seconds or more.
Combination meter
MWI
U1010 CONTROL UNIT (CAN)
MWI-55
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
U1010 CONTROL UNIT (CAN)
Description
INFOID:0000000009174251
Initial diagnosis of combination meter.
DTC Logic
INFOID:0000000009174252
DTC DETECTION LOGIC
Diagnosis Procedure
INFOID:0000000009174253
1.
REPLACE COMBINATION METER
When DTC U1010 is detected, replace combination meter. Refer to
MWI-82, "Removal and Installation"
.
>> Inspection End.
DTC
CONSULT Display
Detection Condition
Possible Cause
U1010
CONTROL UNIT (CAN)
[U1010]
When detecting error during the initial diagnosis of the CAN controller
of combination meter.
Combination meter
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст