Nissan Pathfinder. Manual — part 764
LAN
HOW TO USE THIS SECTION
LAN-9
< HOW TO USE THIS MANUAL >
[CAN FUNDAMENTAL]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
HOW TO USE THIS MANUAL
HOW TO USE THIS SECTION
Information
INFOID:0000000009174922
• “CAN FUNDAMENTAL” of LAN Section describes the basic knowledge of the CAN communication system
and the method of trouble diagnosis.
• For information peculiar to a vehicle and inspection procedure, refer to “CAN”.
LAN-10
< PRECAUTION >
[CAN FUNDAMENTAL]
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precautions for Trouble Diagnosis
INFOID:0000000009174923
CAUTION:
Follow the instructions listed below. Failure to do this may cause damage to parts:
• Never apply 7.0 V or more to the measurement terminal.
• Use a tester with open terminal voltage of 7.0 V or less.
• Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when
checking the harness.
Precautions for Harness Repair
INFOID:0000000009174924
• Solder the repaired area and wrap tape around the soldered area.
NOTE:
A fray of twisted lines must be within 110 mm (4.33 in).
• Bypass connection is never allowed at the repaired area.
NOTE:
Bypass connection may cause CAN communication error. The
spliced wire becomes separated and the characteristics of twisted
line are lost.
• Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communica-
tion line.
SKIB8766E
SKIB8767E
LAN
SYSTEM
LAN-11
< SYSTEM DESCRIPTION >
[CAN FUNDAMENTAL]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
SYSTEM DESCRIPTION
SYSTEM
CAN COMMUNICATION SYSTEM
CAN COMMUNICATION SYSTEM : System Description
INFOID:0000000009174925
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle mul-
tiplex communication line with high data communication speed and excellent error detection ability. Many elec-
tronic control units are equipped onto a vehicle, and each control unit shares information and links with other
control units during operation (not independent). In CAN communication, control units are connected with 2
communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.
DIAG ON CAN
DIAG ON CAN : System Description
INFOID:0000000009174926
SYSTEM DIAGRAM
JSMIA0526GB
LAN-12
< SYSTEM DESCRIPTION >
[CAN FUNDAMENTAL]
SYSTEM
DESCRIPTION
“Diag on CAN” is a diagnosis method which uses the CAN communication line for the communication between
the control unit and the diagnostic tool.
Name
Harness
Description
DDL1
Tx
Rx
For communications with the diagnostic tool. (CAN-H and CAN-L are used for control-
ling)
DDL2
K-LINE
For communications with the diagnostic tool. (CAN-H and CAN-L are used for control-
ling)
Diag on CAN
CAN-H
CAN-L
For communications with the diagnostic tool. (CAN-H and CAN-L are also used for con-
trol and diagnoses.)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст