Nissan Pathfinder. Manual — part 1119
HYDRAULIC LINE
ST-55
< REMOVAL AND INSTALLATION >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
4WD
Removal and Installation
INFOID:0000000009177111
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spill-
ing.
AWGIA0302ZZ
1.
Cover
2.
Power steering pump
3.
Low pressure piping (up-
per)
4.
High pressure piping
5.
Engine mount
6.
Engine mount bracket
7.
Power steering gear
8.
High pressure piping (lower)
9.
O-ring
A.
Steering gear connection detail
B.
Power steering pump connection
detail
Front
ST-56
< REMOVAL AND INSTALLATION >
HYDRAULIC LINE
REMOVAL
Refer to the component parts location illustration for hydraulic line removal. Refer to
CAUTION:
• Do not reuse O-rings.
INSTALLATION
Installation is in the reverse order of removal.
• Bleed air from power steering system. Refer to
ST-42, "Air Bleeding Hydraulic System"
.
• Check for fluid leaks. Repair as necessary.
CAUTION:
• Do not reuse O-rings.
STEERING GEAR AND LINKAGE
ST-57
< UNIT DISASSEMBLY AND ASSEMBLY >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
UNIT DISASSEMBLY AND ASSEMBLY
STEERING GEAR AND LINKAGE
Exploded View
INFOID:0000000009177112
Disassembly and Assembly
INFOID:0000000009177113
DISASSEMBLY
1. Remove outer socket locknut and outer socket.
2. Remove boot clamps and boot.
3. Remove inner socket.
ASSEMBLY
1. Apply Three Bond 1111B or equivalent to inner socket and turn pinion fully to retract inner socket into gear
housing.
1.
Steering gear
2.
Inner socket
3.
Inner boot clamp
4.
Boot
5.
Outer boot clamp
6.
Outer socket
Front
AWGIA0303ZZ
ST-58
< UNIT DISASSEMBLY AND ASSEMBLY >
STEERING GEAR AND LINKAGE
2. Install large end (1) of boot (2) to gear housing.
3. Install small end (3) of boot (2) to inner socket boot mounting
groove.
4. Install boot clamp to boot small end.
5. Install boot clamp to boot large end using suitable tool.
CAUTION:
Do not reuse boot clamps.
6. Adjust inner socket to standard length (L), and then tighten lock
nut to the specified torque. Check length of inner socket (L)
again after tightening lock nut. Make sure that the length is the
standard.
CAUTION:
Adjust toe-in after this procedure. The length achieved after
toe-in adjustment is not necessarily the above value.
AWGIA0107ZZ
AST139
Inner socket length (L)
: Refer to
SGIA0167E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст