Nissan Pathfinder. Manual — part 725
INTAKE SENSOR
HAC-161
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
INTAKE SENSOR
Removal and Installation
INFOID:0000000009176901
The intake sensor is not serviced separately. Refer to
HA-45, "EVAPORATOR : Removal and Installation -
.
HAC-162
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
REFRIGERANT PRESSURE SENSOR
REFRIGERANT PRESSURE SENSOR
Removal and Installation
INFOID:0000000009176902
REMOVAL
1. Discharge the refrigerant. Refer to
2. Remove the core support cover. Refer to
3. Disconnect the harness connector from the refrigerant pressure sensor.
4. Remove the refrigerant pressure sensor (1).
CAUTION:
Cap or wrap the opening of the refrigerant pressure sensor
with suitable material such as vinyl tape to avoid the entry
of air.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Do not reuse O-ring.
• Apply A/C oil to the O-ring of the refrigerant pressure sensor for installation.
• After charging the refrigerant, check for leaks. Refer to
ALIIA0698ZZ
DOOR MOTOR
HAC-163
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
C
D
E
F
G
H
J
K
L
M
A
B
HAC
N
O
P
DOOR MOTOR
Exploded View
INFOID:0000000009176903
Front Door Motors
AWIIA1700ZZ
1. Intake door motor
2. Mode door motor (front)
3. Air mix door motor (driver side)
4. Air mix door motor (passenger side)
5. Air mix door motor (rear)
6. Front heating and cooling unit assembly
HAC-164
< REMOVAL AND INSTALLATION >
[AUTOMATIC AIR CONDITIONING]
DOOR MOTOR
Rear Door Motors
MODE DOOR MOTOR
MODE DOOR MOTOR : Removal and Installation - Mode Door Motor (Front)
INFOID:0000000009176904
REMOVAL
1. Remove the center console side finisher (LH). Refer to
.
2. Remove the front foot duct (LH). Refer to
HA-41, "HEATING AND COOLING UNIT ASSEMBLY :
Exploded View - Front Heating and Cooling Unit Assembly"
.
3. Remove the mode door motor (front) screws.
4. Disconnect the harness connector from the mode door motor (front) and remove.
INSTALLATION
Installation is in the reverse order of removal.
MODE DOOR MOTOR : Removal and Installation - Mode Door Motor (Rear)
INFOID:0000000009176905
REMOVAL
1. Remove the center console assembly. Refer to
IP-18, "Removal and Installation"
2. Disconnect the harness connectors from the PTC heater.
3. Remove the screws from the mode door motor (rear).
4. Disconnect the harness connector from the mode door motor (rear) and remove.
INSTALLATION
Installation is in the reverse order of removal.
AWIIA1623ZZ
1. Rear blower motor 1 unit assembly
2. Rear shut-off door motor
3. Mode door motor (rear)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст