Nissan Pathfinder. Manual — part 308
FILAMENT
DEF-51
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
DEF
N
O
P
REMOVAL AND INSTALLATION
FILAMENT
Inspection and Repair
INFOID:0000000009175589
INSPECTION
1. When measuring voltage, wrap tin foil around the top of the neg-
ative probe. Then press the foil against the wire with your finger.
2. Attach probe circuit tester (in Volt range) to middle portion of
each filament.
3. If a filament is burned out, circuit tester registers 0 or battery
voltage.
4. To locate burned out point, move probe to left and right along fil-
ament. Test needle will swing abruptly when probe passes the
point.
REPAIR
REPAIR EQUIPMENT
• Conductive silver composition (Dupont No. 4817 or equivalent)
SEL122R
SEL263
SEL265
DEF-52
< REMOVAL AND INSTALLATION >
FILAMENT
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
1. Wipe broken heat wire and its surrounding area clean with a
cloth dampened in alcohol.
2. Apply a small amount of conductive silver composition to tip of
drawing pen.
NOTE:
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit conductive silver
composition on break with drawing pen. Slightly overlap existing
heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
4. After repair has been completed, check repaired wire for conti-
nuity. This check should be conducted 10 minutes after silver
composition is deposited.
CAUTION:
Do not touch repaired area while test is being conducted.
5. Apply a constant stream of hot air directly to the repaired area
for approximately 20 minutes with a heat gun. A minimum dis-
tance of 3 cm (1.2 in) should be kept between repaired area and
hot air outlet.
NOTE:
If a heat gun is not available, let the repaired area dry for 24
hours.
PIIA0215E
SEL012D
SEL013D
CONDENSER
DEF-53
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
DEF
N
O
P
CONDENSER
Removal and Installation
INFOID:0000000009175590
REMOVAL
1. Remove the back door lower finisher. Refer to
INT-35, "BACK DOOR LOWER FINISHER : Removal and
.
2. Disconnect the harness connectors (A) from the condenser (1).
3. Remove the bolt (B) and the condenser (1).
INSTALLATION
Installation is in the reverse order of removal.
AWLIA2141ZZ
DLK-1
BODY EXTERIOR, DOORS, ROOF & VEHICLE SECURITY
C
D
E
F
G
H
I
J
L
M
SECTION
DLK
A
B
DLK
N
O
P
CONTENTS
DOOR & LOCK
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
Precaution for Servicing Doors and Locks . . . ....
PREPARATION . . . . . . . . . . ...
PREPARATION . . . . . . . . . . . . ..
Special Service Tool . . . . . . . . . . . ...
Commercial Service Tool . . . . . . . . . .
SYSTEM DESCRIPTION . . . . . . . .
COMPONENT PARTS . . . . . . . . . ...
POWER DOOR LOCK SYSTEM . . . . . . . ...
POWER DOOR LOCK SYSTEM :
Component Parts Location . . . . . . . . .
POWER DOOR LOCK SYSTEM :
Component Description . . . . . . . . . . ..
INTELLIGENT KEY SYSTEM . . . . . . . . ...
INTELLIGENT KEY SYSTEM : Component Parts
Location . . . . . . . . . . . . . . . . ...
INTELLIGENT KEY SYSTEM :
Component Description . . . . . . . . . . ..
INTEGRATED HOMELINK TRANSMITTER . . . .
INTEGRATED HOMELINK TRANSMITTER :
Component Parts Location . . . . . . . . . ..
INTEGRATED HOMELINK TRANSMITTER :
Component Description . . . . . . . . . . ...
AUTOMATIC BACK DOOR SYSTEM . . . . . ...
AUTOMATIC BACK DOOR SYSTEM :
Component Parts Location . . . . . . . . .
AUTOMATIC BACK DOOR SYSTEM :
Component Description . . . . . . . . . . ..
SYSTEM (POWER DOOR LOCK SYSTEM) . .
System Diagram . . . . . . . . . . . . . ..
System Description . . . . . . . . . . . . ..
SYSTEM (INTELLIGENT KEY SYSTEM) . . .
INTELLIGENT KEY SYSTEM . . . . . . . . .
INTELLIGENT KEY SYSTEM : System Diagram .
INTELLIGENT KEY SYSTEM : System Descrip-
tion . . . . . . . . . . . . . . . . . . ...
DOOR LOCK FUNCTION . . . . . . . . . . ..
DOOR LOCK FUNCTION : System Diagram . . ..
DOOR LOCK FUNCTION : System Description . .
BACK DOOR OPEN FUNCTION . . . . . . . ...
BACK DOOR OPEN FUNCTION : System Dia-
gram . . . . . . . . . . . . . . . . . .
BACK DOOR OPEN FUNCTION : System De-
scription . . . . . . . . . . . . . . . . ...
REMOTE KEYLESS ENTRY FUNCTION . . . . ..
REMOTE KEYLESS ENTRY FUNCTION : Sys-
tem Diagram . . . . . . . . . . . . . . .
REMOTE KEYLESS ENTRY FUNCTION : Sys-
tem Description . . . . . . . . . . . . . .
KEY REMINDER FUNCTION . . . . . . . . .
KEY REMINDER FUNCTION : System Diagram .
KEY REMINDER FUNCTION : System Descrip-
tion . . . . . . . . . . . . . . . . . . ...
REMOTE ENGINE START FUNCTION . . . . . .
REMOTE ENGINE START FUNCTION : System
Diagram . . . . . . . . . . . . . . . . ...
REMOTE ENGINE START FUNCTION : System
Description . . . . . . . . . . . . . . . ...
WELCOME LIGHT FUNCTION . . . . . . . . .
WELCOME LIGHT FUNCTION : System Diagram
WELCOME LIGHT FUNCTION : System Descrip-
tion . . . . . . . . . . . . . . . . . . ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст