Nissan Pathfinder. Manual — part 141
AV
PRECAUTIONS
AV-391
< PRECAUTION >
[PREMIUM AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
• Solder the repaired parts, and wrap with tape. [Frays of twisted line
must be within 110 mm (4.33 in).]
• Do not perform bypass wire connections for the repair parts. (The
spliced wire will become separated and the characteristics of
twisted line will be lost.)
Precaution for Work
INFOID:0000000009174654
• When removing or disassembling each component, be careful not to damage or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
• When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component
with a shop cloth or vinyl tape to protect it.
• Protect the removed parts with a shop cloth and prevent them from being dropped.
• Replace a deformed or damaged clip.
• If a part is specified as a non-reusable part, always replace it with a new one.
• Be sure to tighten bolts and nuts securely to the specified torque.
• After installation is complete, be sure to check that each part works properly.
• Follow the steps below to clean components:
- Water soluble dirt:
• Dip a soft cloth into lukewarm water, wring the water out of the cloth and wipe the dirty area.
• Then rub with a soft, dry cloth.
- Oily dirt:
• Dip a soft cloth into lukewarm water with mild detergent (concentration: within 2 to 3%) and wipe the dirty
area.
• Then dip a cloth into fresh water, wring the water out of the cloth and wipe the detergent off.
• Then rub with a soft, dry cloth.
- Do not use organic solvent such as thinner, benzene, alcohol or gasoline.
- For genuine leather seats, use a genuine leather seat cleaner.
PKIA0306E
PKIA0307E
AV-392
< PREPARATION >
[PREMIUM AUDIO WITH NAVIGATION]
PREPARATION
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000009174655
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tools
INFOID:0000000009174656
Tool number
(Kent-Moore No.)
Tool name
Description
—
(J-46534)
Trim tool set
Removing trim components
AWJIA0483ZZ
(Kent-Moore No.)
Tool name
Description
( — )
Power tools
Loosening nuts, screws and bolts
PIIB1407E
AV
COMPONENT PARTS
AV-393
< SYSTEM DESCRIPTION >
[PREMIUM AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
SYSTEM DESCRIPTION
COMPONENT PARTS
Component Parts Location
INFOID:0000000009174657
AWNIA2808ZZ
AV-394
< SYSTEM DESCRIPTION >
[PREMIUM AUDIO WITH NAVIGATION]
COMPONENT PARTS
ALNIA1447ZZ
1.
Front tweeter LH
2.
Instrument panel tweeter LH
3.
Steering switches
4.
A/C and AV switch assembly
5.
Front tweeter RH
6.
Instrument panel tweeter RH
7.
Display unit
8.
Center speaker
9.
AV control unit (view with center stack
removed)
10. Microphone
11. USB interface
12. Front auxiliary input jacks
13. Front door speaker LH
14. Front door speaker RH
15. Rear door speaker LH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст