Nissan Pathfinder. Manual — part 1001
SE-2
SEATBACK THERMAL ELECTRIC DEVICE
SENSOR . . . . . . . . . . . . . . .
Component Function Check . . . . . . . . .
Diagnosis Procedure . . . . . . . . . . . ..
Component Inspection . . . . . . . . . . ....
SEAT CUSHION THERMAL ELECTRIC DE-
VICE . . . . . . . . . . . . . . . . ...
Component Function Check . . . . . . . . .
Diagnosis Procedure . . . . . . . . . . . ..
SEAT CUSHION THERMAL ELECTRIC DE-
VICE SENSOR . . . . . . . . . . . . ...
Component Function Check . . . . . . . . .
Diagnosis Procedure . . . . . . . . . . . ..
Component Inspection . . . . . . . . . . ....
CLIMATE CONTROLLED SEAT BLOWER
MOTOR . . . . . . . . . . . . . . . ..
Component Function Check . . . . . . . . .
Diagnosis Procedure . . . . . . . . . . . ..
CLIMATE CONTROLLED SEAT SWITCH IN-
DICATOR . . . . . . . . . . . . . . ...
Component Function Check . . . . . . . . .
Diagnosis Procedure . . . . . . . . . . . ..
CLIMATE CONTROLLED SEAT BLOWER
FILTER . . . . . . . . . . . . . . . ...
Diagnosis Procedure . . . . . . . . . . . ..
SYMPTOM DIAGNOSIS . . . . . . . .
CLIMATE CONTROLLED SEAT SYSTEM . ...
Symptom Table . . . . . . . . . . . . . ..
SQUEAK AND RATTLE TROUBLE DIAG-
NOSES . . . . . . . . . . . . . . . ...
Work Flow . . . . . . . . . . . . . . . ...
Generic Squeak and Rattle Troubleshooting . . ..
Diagnostic Worksheet . . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . ...
FRONT SEAT . . . . . . . . . . . . .
Exploded View . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Seatback Board . . . . . . . . . . . . . ..
Seatback Thermal Electric Device . . . . . . ..
Seat Cushion Thermal Electric Device . . . . ...
Blower Motor Filter . . . . . . . . . . . . ..
Blower Motor . . . . . . . . . . . . . . ...
SECOND ROW SEATS . . . . . . . . . .
Exploded View . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
Armrest Assembly . . . . . . . . . . . . ...
Seat Cushion . . . . . . . . . . . . . . ..
Seat Cushion Release Cable . . . . . . . . ..
Seat Slide Release Cable . . . . . . . . . .
Recline Release Cable Assembly . . . . . . .
EZ Entry Cable . . . . . . . . . . . . . ..
RH Seat Track Tilt Release Cable . . . . . .
THIRD ROW SEATS . . . . . . . . . .
Exploded View . . . . . . . . . . . . . ..
Removal and Installation . . . . . . . . . ...
UNIT DISASSEMBLY AND ASSEMBLY ..
FRONT SEAT . . . . . . . . . . . . ...
Exploded View . . . . . . . . . . . . . ..
Seatback . . . . . . . . . . . . . . . ...
Seat Cushion . . . . . . . . . . . . . .
SECOND ROW SEAT . . . . . . . . . ..
Exploded View . . . . . . . . . . . . . ..
LH SEAT . . . . . . . . . . . . . . . . ..
LH SEAT : Seatback . . . . . . . . . . . .
LH SEAT : Seat Cushion . . . . . . . . . ..
RH SEAT . . . . . . . . . . . . . . . . .
RH SEAT : Seatback . . . . . . . . . . .
RH SEAT : Seat Cushion . . . . . . . . . ..
THIRD ROW SEAT . . . . . . . . . . ...
Exploded View . . . . . . . . . . . . . ..
Seatback . . . . . . . . . . . . . . . ...
PRECAUTIONS
SE-3
< PRECAUTION >
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000009754961
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the SR and SB section of
this Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SR section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
• When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Igni-
tion ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a
hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing
serious injury.
• When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the
battery and wait at least three minutes before performing any service.
Occupant Classification System
INFOID:0000000009760392
Replace occupant classification system as part of the passenger front seat frame assembly. Refer to
Precaution for Work
INFOID:0000000009754962
• When removing or disassembling each component, be careful not to damage or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
• When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component
with a shop cloth or vinyl tape to protect it.
• Protect the removed parts with a shop cloth and prevent them from being dropped.
• Replace a deformed or damaged clip.
• If a part is specified as a non-reusable part, always replace it with a new one.
• Be sure to tighten bolts and nuts securely to the specified torque.
• After installation is complete, be sure to check that each part works properly.
• Follow the steps below to clean components:
- Water soluble dirt:
• Dip a soft cloth into lukewarm water, wring the water out of the cloth and wipe the dirty area.
• Then rub with a soft, dry cloth.
- Oily dirt:
• Dip a soft cloth into lukewarm water with mild detergent (concentration: within 2 to 3%) and wipe the dirty
area.
• Then dip a cloth into fresh water, wring the water out of the cloth and wipe the detergent off.
• Then rub with a soft, dry cloth.
- Do not use organic solvent such as thinner, benzene, alcohol or gasoline.
- For genuine leather seats, use a genuine leather seat cleaner.
SE-4
< PREPARATION >
PREPARATION
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000009754970
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Tool number
(Kent-Moore No.)
Tool name
Description
—
(J-39570)
Chassis Ear
Locating the noise
—
(J-50397)
NISSAN Squeak and Rattle
Kit
Repairing the cause of noise
—
(J-46534)
Trim Tool Set
Removing trim components
—
(J-51030)
Seat Fixture Kit
Securing second row seat slides for removal
and installation of seat assembly
SIIA0993E
ALJIA1232ZZ
AWJIA0483ZZ
ALJIA1118ZZ
PREPARATION
SE-5
< PREPARATION >
C
D
E
F
G
H
I
K
L
M
A
B
SE
N
O
P
Commercial Service Tool
INFOID:0000000009754971
(Kent-Moore No.)
Tool name
Description
(J-39565)
Engine Ear
Locating the noise
( — )
Hook and Pick Tool
Removes snap rings
SIIA0995E
JMJIA0490ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст