Nissan X-Trail 32. Manual — part 491
FRONT DOOR LOCK
DLK-305
< REMOVAL AND INSTALLATION >
[TYPE 1]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
7.
Disconnect door harness connector
and disengage outside handle harness connector fixing clip
.
8.
Disengage rod holder
and disconnect key rod
from door lock assembly
according to the numerical
order 1
→
2 indicated by arrows as shown in the figure (driver side).
9.
Remove door side grommet
, and then loosen TORX bolt
from grommet hole.
: Clip
: Vehicle front
: Vehicle front
JMKIB3671ZZ
JMKIB3672ZZ
JMKIB3066ZZ
DLK-306
< REMOVAL AND INSTALLATION >
[TYPE 1]
FRONT DOOR LOCK
10. Remove outside handle escutcheon
while pulling outside
handle grip
according to the numerical order 1
→
2 indicated
by arrows as shown in the figure.
11. Slide outside handle grip
toward rear of vehicle and remove it
according to the numerical order 1
→
2 indicated by arrows as
shown in the figure.
12. Remove front gasket
and rear gasket
.
13. Slide outside handle bracket toward rear of vehicle and remove
it.
JMKIA0441ZZ
JMKIA2948ZZ
: Pawl
: Vehicle front
JMKIB2240ZZ
: Vehicle front
JMKIB2241ZZ
FRONT DOOR LOCK
DLK-307
< REMOVAL AND INSTALLATION >
[TYPE 1]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
14. Disconnect outside handle cable
from outside handle bracket
according to the numerical order 1
→
2 indicated by arrows as
shown in the figure.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• When installing outside handle cable to outside handle, be careful that outside handle cable is
routed normally.
• When installing key rod, rotate key rod holder until a click is felt.
• After installation, check door lock. Refer to
DLK-303, "DOOR LOCK : Inspection"
.
JMKIB2242ZZ
DLK-308
< REMOVAL AND INSTALLATION >
[TYPE 1]
REAR DOOR LOCK
REAR DOOR LOCK
Exploded View
INFOID:0000000010708299
DOOR LOCK
DOOR LOCK : Removal and Installation
INFOID:0000000010708300
REMOVAL
1.
Disconnect inside handle cable from inside handle. Refer to
DLK-309, "INSIDE HANDLE : Removal and
.
2.
Disconnect outside handle cable from outside handle bracket. Refer to
.
3.
Disconnect door lock assembly connector.
4.
Remove door lock assembly TORX bolts, and then remove door lock assembly.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Never reuse TORX bolt. Always replace it with a new one when it is removed.
Outside handle escutcheon
Outside handle grip
Inside handle
Door lock assembly
TORX bolt
Rear gasket
Front gasket
Outside handle bracket
: Pawl
: Vehicle front
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
: Body grease
JMKIB3684GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст