Nissan X-Trail 32. Manual — part 2245
REAR WIPER
WW-87
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
REAR WIPER
Exploded View
INFOID:0000000010785453
WIPER ARM
WIPER ARM : Removal and Installation
INFOID:0000000010785454
CAUTION:
Clean the back door window glass and rear wiper refill so that the back door window glass may not be
damaged by dust, etc.
REMOVAL
1.
Operate rear wiper to the auto stop position.
Rear wiper motor assembly
Pivot seal
Rear wiper arm cover
Rear wiper arm
Rear wiper blade
Rear wiper refill
: Pawl
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
JMLIA5003GB
WW-88
< REMOVAL AND INSTALLATION >
REAR WIPER
2.
Open rear wiper arm cover, and then remove rear wiper arm
mounting nut
.
3.
Pull up rear wiper arm, and then remove rear wiper arm from vehicle.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Clean wiper arm installation location as shown in the figure,
and then fully insert wiper arm to prevent nut from being loos-
ened by shakiness.
• When installing rear wiper arm, install so that it is within the standard. For the standard, refer to
.
• After installation, operate rear wiper, and then check that the rear wiper blade stop at the specified
position. Refer to
WW-88, "WIPER ARM : Adjustment"
.
WIPER ARM : Adjustment
INFOID:0000000010785455
REAR WIPER ARM POSITION ADJUSTMENT
Adjust tip of rear wiper blade as shown in the figure.
: Pawl
JMLIA4855ZZ
SKIA0082J
Back door window glass
Rear wiper assembly
Rear window defogger
Back door panel
JMLIA5013ZZ
REAR WIPER
WW-89
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
Standard clearance from rear window defogger.
WIPER BLADE
WIPER BLADE : Removal and Installation
INFOID:0000000010785456
REMOVAL
1.
Lift up and hold rear wiper arm.
2.
Remove rear wiper blade
from rear wiper arm
while rotating rear wiper blade in the direction indi-
cated by the arrow as shown in the figure.
CAUTION:
After rear wiper blade is removed, wrap rear wiper arm tip with a shop cloth and fold it down so
that rear wiper arm does not fall against and damage back door window glass.
INSTALLATION
Install in the reverse order of removal.
WIPER MOTOR
WIPER MOTOR : Removal and Installation
INFOID:0000000010785457
REMOVAL
1.
Remove rear wiper arm. Refer to
WW-87, "WIPER ARM : Removal and Installation"
.
2.
Remove back door trim. Refer to
INT-47, "Removal and Installation"
3.
Disconnect rear wiper motor assembly harness connector.
4.
Remove rear wiper motor mounting bolts, and then remove rear wiper motor assembly form back door
panel.
CAUTION:
Never drop rear wiper motor or cause it to come into contact with other parts.
5.
Remove pivot seal from back door panel.
INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:
Always install pivot seal with
“
”
mark facing upward as shown
in the figure.
B : 7.5 mm (0.30 in)
JMLIA1989ZZ
JMLIA3297ZZ
WW-90
< REMOVAL AND INSTALLATION >
WASHER TANK
WASHER TANK
Exploded View
INFOID:0000000010785458
Washer tank cap
Washer tank tube
Washer tank inlet
JMLIA5004GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст