Nissan X-Trail 32. Manual — part 1135
EX-16
< PERIODIC MAINTENANCE >
[R9M]
EXHAUST SYSTEM
PERIODIC MAINTENANCE
EXHAUST SYSTEM
Inspection
INFOID:0000000010782900
Check exhaust pipes, muffler, and mounting for improper attach-
ment, leakage, cracks, damage or deterioration.
• If anything is found, repair or replace damaged parts.
SMA211A
EXHAUST SYSTEM
EX-17
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EX
N
P
O
REMOVAL AND INSTALLATION
EXHAUST SYSTEM
Exploded View
INFOID:0000000010782901
2WD models
JSBIA5143GB
Gasket
Exhaust front tube
Mounting rubber
Gasket
Mounting rubber
Main muffler
Mounting rubber
Mounting rubber
To DPF (diesel particulate filter)
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
: Indicates that the part is connected at points with same symbol in actual vehicle.
EX-18
< REMOVAL AND INSTALLATION >
[R9M]
EXHAUST SYSTEM
4WD models
Removal and Installation
INFOID:0000000010782902
REMOVAL
• Disconnect each joint and mounting.
INSTALLATION
Note the following, and install in the reverse order of removal.
CAUTION:
• Always replace gaskets with new ones when reassembling.
• If heat insulator is badly deformed, repair or replace it. If deposits such as mud pile up on the heat
insulator, remove them.
• When installing heat insulator avoid large gaps or interference between heat insulator and each
exhaust pipe.
• Remove deposits from the sealing surface of each connection. Connect them securely to avoid gas
leakage.
• Temporarily tighten mounting nuts and bolts. Check each part for unusual interference and mount-
ing rubber interference, and then tighten them to the specified torque.
• When installing each mounting rubber, avoid twisting or unusual extension in up/down, front/rear
and right/left directions.
• Install mounting rubber, refer to the following instructions,
JSBIA5144GB
Gasket
Exhaust front tube
Mounting rubber
Gasket
Mounting rubber
Main muffler
Mounting rubber
Mounting rubber
To DPF (diesel particulate filter)
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
: Indicates that the part is connected at points with same symbol in actual vehicle.
EXHAUST SYSTEM
EX-19
< REMOVAL AND INSTALLATION >
[R9M]
C
D
E
F
G
H
I
J
K
L
M
A
EX
N
P
O
- Install slit of the mounting rubber
is in a horizontal direction.
Inspection
INFOID:0000000010782903
INSPECTION AFTER INSTALLATION
• Check clearance between tail tube and rear bumper is even.
• With engine running, check exhaust tube joints for gas leakage and unusual noises.
• Check to ensure that mounting brackets and mounting rubbers are installed properly and free from undue
stress. Improper installation could result in excessive noise and vibration.
: RH
: LH
: Vehicle upper
JPBIA6874ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст