Nissan X-Trail 32. Manual — part 1722
PG-142
< REMOVAL AND INSTALLATION >
BATTERY
EXCEPT FOR R9M : Removal and Installation
INFOID:0000000010709237
REMOVAL
1.
Disconnect the battery cable from the negative terminal.
CAUTION:
To prevent damage to the parts, disconnect the battery cable from the negative terminal first.
2.
Remove cover of battery positive terminal.
3.
Disconnect the battery cable from the positive terminal.
4.
Remove battery fix frame mounting nuts and battery fix frame.
5.
Remove battery.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
To install the battery, carefully read the following instructions.
• To prevent damage to the parts, connect the battery cable to the positive terminal first.
• After connecting battery cables, to securely supply battery voltage, ensure that they are tightly
clamped to battery terminals for good contact.
• To securely supply battery voltage, check battery terminal for poor connection caused by corrosion.
Reset electronic systems as necessary. Refer to
GI-61, "ADDITIONAL SERVICE WHEN REMOVING BAT-
TERY NEGATIVE TERMINAL : Required Procedure After Battery Disconnection"
Battery tray
TCM mounting bracket
Battery under cover
Battery
Battery negative terminal
: N·m (kg-m, in-lb)
: Vehicle front
PG
BATTERY TRAY
PG-143
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
BATTERY TRAY
R9M
R9M : Exploded View
INFOID:0000000010763413
R9M : Removal and Installation
INFOID:0000000010763262
REMOVAL
Battery fix frame
Battery fix rod
Battery positive terminal cover
Battery terminal with fusible link
Battery cover
TCM mounting bracket
Battery tray
Starter relay bracket
Battery under cover
Battery
Battery current sensor
: N·m (kg-m, in-lb)
: Vehicle front
JSMIA1778GB
PG-144
< REMOVAL AND INSTALLATION >
BATTERY TRAY
1.
Remove battery. Refer to :
PG-139, "R9M : Removal and Installation"
.
2.
Remove air duct. Refer to :
EM-308, "Removal and Installation"
3.
Remove battery tray under cover.
4.
Remove barometric pressure sensor. (If equipped)
5.
Disengage wiring harness fixing pawls from battery tray.
6.
Remove starter relay bolts
from battery tray.
7.
Remove TCM mounting nuts
from battery tray.
8.
EC-1226, "Removal and Installation"
9.
Remove battery tray mounting bolts
.
INSTALLATION
: Pawl
JSMIA1790ZZ
JSMIA1791ZZ
JSMIA1799ZZ
JSMIA1793ZZ
PG
BATTERY TRAY
PG-145
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
1.
Install bolts to battery tray.
• Temporarily tighten bolts 1.
• Tighten bolt 2 to the specified torque.
• Tighten bolts 1 to the specified torque.
2.
Install in the reverse order of removal.
EXCEPT FOR R9M
: M/T models
: CVT models
JSMIA1794ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст