Nissan X-Trail 32. Manual — part 265
REPLACEMENT OPERATIONS
BRM-221
< REMOVAL AND INSTALLATION >
[FOR RUSSIA]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
: Vehicle front
Replacement part
z
Rear side member extension
z
Rear 3rd seat mounting bracket as-
sembly
JSKIA4034ZZ
BRM-222
< SERVICE DATA AND SPECIFICATIONS (SDS)
[FOR RUSSIA]
BODY ALIGNMENT
SERVICE DATA AND SPECIFICATIONS (SDS)
BODY ALIGNMENT
Body Center Marks (MR20DD Engine Models)
INFOID:0000000010860057
A mark is placed on each part of the body to indicate the vehicle center. When repairing the vehicle frame
(members, pillars, etc.) damaged by an accident which it enables more accurate and effective repair by using
these marks together with body alignment specifications.
Unit: mm (in)
: Vehicle front
Points
Portion
Marks
A
Front roof
Embossment
B
Cowl top
Indent
C
Cowl top
Hole
φ
8 (0.31)
D
Trans control reinforcement
Hole 14
×
12 (0.55
×
0.47)
JSKIA4742ZZ
BODY ALIGNMENT
BRM-223
< SERVICE DATA AND SPECIFICATIONS (SDS)
[FOR RUSSIA]
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Body Center Marks (Except For MR20DD Engine Models)
INFOID:0000000010860060
A mark is placed on each part of the body to indicate the vehicle center. When repairing the vehicle frame
(members, pillars, etc.) damaged by an accident which it enables more accurate and effective repair by using
these marks together with body alignment specifications.
Unit: mm (in)
E
Rear seat crossmember
Embossment
F
Rear roof
Embossment
Points
Portion
Marks
: Vehicle front
Points
Portion
Marks
A
Front roof
Embossment
B
Cowl top
Indent
C
Cowl top
Hole
φ
8 (0.31)
JSKIA4708ZZ
BRM-224
< SERVICE DATA AND SPECIFICATIONS (SDS)
[FOR RUSSIA]
BODY ALIGNMENT
Description
INFOID:0000000010860052
• All dimensions indicated in the figures are actual.
• When using a tracking gauge, adjust both pointers to equal length. Then check the pointers and gauge itself
to make sure there is no free play.
• When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
• Measurements should be taken at the center of the mounting holes.
• An asterisk (*) following the value at the measuring point indicates that the measuring point on the other side
is symmetrically the same value.
• The coordinates of the measurement points are the distances measured from the standard line of
″
X
″
,
″
Y
″
and
″
Z
″
.
•
″
Z
″
: Imaginary base line [200 mm (7.87 in) below datum line (
″
0Z
″
at design plan)]
Engine Compartment (MR20DD Engine Models)
INFOID:0000000010860058
MEASUREMENT
Dimensions marked with
″
*
″
indicate symmetrically identical dimensions on both the right and left hand of the
vehicle.
D
Trans control reinforcement
Hole 14
×
12 (0.55
×
0.47)
E
Rear seat crossmember
Embossment
F
Rear roof
Embossment
Points
Portion
Marks
Vehicle center
Front axle center
Imaginary base line
JSKIA0073GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст