Nissan X-Trail 32. Manual — part 2062
TM-206
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F52A]
SHIFT FORK AND FORK ROD
SHIFT FORK AND FORK ROD
Exploded View
INFOID:0000000010957987
Disassembly and Assembly
INFOID:0000000010919431
DISASSEMBLY
Clutch housing
Retaining pin
Reverse shift fork
Reverse fork rod
Return spring
Striking rod
Striking rod shim
Striking rod adjusting shim
Shift lever (outer)
Shift lever (inner)
Guide bolt
Select lever
Transaxle case
3rd-4th shift fork
3rd-4th fork rod
1st-2nd shift fork
1st-2nd fork rod
5th-6th shift fork
5th-6th fork rod
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
: Select with proper thickness.
PCIB1806E
SHIFT FORK AND FORK ROD
TM-207
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F52A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
For disassembly procedures other than the following items, refer to
TM-129, "2WD : Disassembly and Assem-
TM-159, "4WD : Disassembly and Assembly"
(4WD).
Striking Rod
Remove return spring to striking rod.
ASSEMBLY
For assembly procedures other than the following items, refer to
TM-129, "2WD : Disassembly and Assembly"
TM-159, "4WD : Disassembly and Assembly"
(4WD).
Striking Rod
1.
Temporarily install return spring to striking rod.
CAUTION:
Be careful with the orientation of return spring.
2.
Attach one end of the return spring to striking interlock of striking
rod while holding return spring.
CAUTION:
When installing, check that return spring is securely seated
in the groove of striking interlock of striking rod.
PCIB1867E
PCIB1830E
PCIB1831E
PCIB1833E
TM-208
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F52A]
SHIFT FORK AND FORK ROD
Inspection
INFOID:0000000010919433
STRIKING ROD AND RETURN SPRING
Check contact surfaces and sliding area for wear, damage, bending,
etc. If necessary, replace parts.
FORK ROD AND SHIFT FORK
• Check contact surfaces and sliding area for wear, damage, bend-
ing, etc. If necessary, replace parts.
JPDIC0145ZZ
PCIB1869E
SHIFT FORK AND FORK ROD
TM-209
< UNIT DISASSEMBLY AND ASSEMBLY >
[6MT: RS6F52A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
• Check if the width of shift fork hook (sliding area with coupling
sleeve) is within allowable specification below.
One-side wear specification
: Refer to
Sliding width of new part
: Refer to
SMT801D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст