Nissan X-Trail 32. Manual — part 480
SQUEAK AND RATTLE TROUBLE DIAGNOSES
DLK-261
< SYMPTOM DIAGNOSIS >
[TYPE 1]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
PIIB8742E
DLK-262
< REMOVAL AND INSTALLATION >
[TYPE 1]
HOOD
REMOVAL AND INSTALLATION
HOOD
Exploded View
INFOID:0000000010708248
HOOD ASSEMBLY
HOOD ASSEMBLY : Removal and Installation
INFOID:0000000010708249
CAUTION:
• Perform work with 2 workers, because of its heavy weight.
• Use protective tape or shop cloth to protect from damage during removal and installation.
REMOVAL
1.
Support hood assembly with the proper material to prevent it from falling.
WARNING:
Injury may occur if hood assembly is not supported with appropriate material when removing
hood assembly.
2.
Remove hood assembly mounting nuts, and then remove hood assembly.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
Hood assembly
Bumper rubber
Hood rod grommet
Radiator core seal
Radiator core seal RH
Radiator core seal
Radiator core seal LH
Hood insulator
Hood bumper rubber
Hood hinge
Hood rod clamp
Hood support rod
: Pawl
: Body grease
JMKIB2689ZZ
HOOD
DLK-263
< REMOVAL AND INSTALLATION >
[TYPE 1]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
• Before installation of hood, apply anticorrosive agent onto the mounting surface of the hood hinge.
• After installing, perform hood fitting adjustment. Refer to
DLK-263, "HOOD ASSEMBLY : Adjust-
• Apply touch-up paint to the body color if the paint around the hinge is peeled off during removal.
• After installation, check that hood opens and closes normally. Refer to
.
HOOD ASSEMBLY : Inspection
INFOID:0000000010708250
1.
Open and close the hood. Check that hood hinge rotation portion moves smoothly.
2.
Check hood hinge rotating part for poor lubrication. If necessary,
apply grease.
HOOD ASSEMBLY : Adjustment
INFOID:0000000010708251
FITTING ADJUSTMENT
: Body grease
JMKIB2933ZZ
DLK-264
< REMOVAL AND INSTALLATION >
[TYPE 1]
HOOD
Fitting Adjustment Standard
Check the clearance and the surface height between hood and each part by visually and touching.
If the clearance and the surface height are out of specification, adjust them according to the procedures
shown below.
Hood assembly
Front grille
Front combination lamp
Front fender
Hood bumper rubber
Hood hinge
Hood lock assembly
: Vehicle front
: N·m (kg-m, ft-lb)
: Body grease
JMKIB2934GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст