Nissan X-Trail 32. Manual — part 1345
CONDENSER
HA-39
< REMOVAL AND INSTALLATION >
[R9M (EXCEPT FOR RUSSIA)]
C
D
E
F
G
H
J
K
L
M
A
B
HA
N
O
P
4.
Remove mounting bolt
, and then disconnect high-pressure
pipe 2 from the condenser & liquid tank assembly.
CAUTION:
Cap or wrap the joint of the A/C piping and condenser with
suitable material such as vinyl tape to avoid the entry of air.
5.
Disengage fixing pawls, and then remove the condenser & liquid tank assembly from the vehicle accord-
ing to numerical order 1
→
2 indicated by arrows as shown in the figure.
CAUTION:
Never to damage core surface of condenser.
INSTALLATION
Note the following items, and then install in the reverse order of removal.
CAUTION:
• Replace O-rings with new ones. Then apply compressor oil to them when installing.
• Perform lubricant adjusting procedure before installing new condenser. Refer to
Adjusting Procedure for Compressor Replacement"
• Check for leakages when recharging refrigerant. Refer to
JMIIA3742ZZ
: Pawl
JMIIA3744ZZ
HA-40
< REMOVAL AND INSTALLATION >
[R9M (EXCEPT FOR RUSSIA)]
A/C UNIT ASSEMBLY
A/C UNIT ASSEMBLY
Exploded View
INFOID:0000000011000244
REMOVAL
RHD models
JMIIA3405GB
A/C unit assembly
Drain hose
Cap
Instrument stay LH
Instrument stay RH
Steering member
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
A/C UNIT ASSEMBLY
HA-41
< REMOVAL AND INSTALLATION >
[R9M (EXCEPT FOR RUSSIA)]
C
D
E
F
G
H
J
K
L
M
A
B
HA
N
O
P
LHD models
DISASSEMBLY
JMIIA3519GB
Cap
Steering member
Instrument stay LH
Instrument stay RH
A/C unit assembly
Drain hose
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
HA-42
< REMOVAL AND INSTALLATION >
[R9M (EXCEPT FOR RUSSIA)]
A/C UNIT ASSEMBLY
A/C UNIT ASSEMBLY
Heater & cooling unit case RH
Blower motor assembly
Filter cover RH
Sub harness
PTC heater
O-ring
Expansion valve
Main case center
Sub harness
Cooler packing
Heater pipe packing
Intake packing
Heater pipe clamp
Air conditioner filter
Evaporator assembly
Case packing
Heater & cooling unit case LH
Heater core
A/C auto amp.
(automatic air conditioning)
Filter cover LH
Intake sensor
Intake box case lower
Heater pipe cover
Aspirator
(automatic air conditioning)
Aspirator duct
(automatic air conditioning)
Intake door
Power transistor
(automatic air conditioning)
Fan control amplifier
(manual air conditioning)
Intake box case upper
Foot door
Plate case center
Air mix door RH
Air mix door LH
Center ventilator door·center ventila-
tor & defroster door rod
Foot door & mode door rod
Side ventilator door
Main case rear
Mode door
Center ventilator & defroster door
Air guide case
Side ventilator packing LH
Center ventilator packing
Side ventilator packing RH
Defroster packing
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
JMIIA3520GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст