Nissan Terrano r20e. Manual — part 375
Changing Transfer Oil
Oil capacity:
2.3 liters (2 Imp qt)
When changing transfer oil completely, either “DEXRON
TM
” type
Automatic Transmission Fluid or gear oil (API GL-4) may be used.
Do not mix Automatic Transmission Fluid and gear oil.
Checking Propeller Shaft
Check propeller shaft for damage, looseness or grease leakage.
Checking Differential Gear Oil
1. Check differential for oil leakage.
2. Check oil level.
YMA010
SMA566
SMA118A
SMA440B
SMA417
CHASSIS AND BODY MAINTENANCE
MA-38
Changing Differential Gear Oil
Oil capacity:
Front
R180A
1.3 liters (2-1/4 Imp pt)
Oil capacity:
Rear
H233B
2.8 liters (4-7/8 Imp pt)
Checking Front Wheel Bearing Grease
I
Check that wheel bearings operate smoothly.
I
Check front wheel bearings for grease leakage and water or
dust entry.
I
Replace front wheel bearings or front wheel bearing grease if
wheel bearings do not turn smoothly.
Repacking Front Wheel Bearing Grease
Apply multi-purpose grease sparingly to the following parts:
I
Threaded portion of spindle
I
Contact surface between wheel bearing washer and outer
wheel bearing
I
Grease seal lip
I
Hub cap or wheel hub (as shown at left)
YMA011
SMA617
YMA012
SMA571A
YMA013
CHASSIS AND BODY MAINTENANCE
Checking Differential Gear Oil (Cont’d)
MA-39
Checking Free-running Hub Grease
Check free-running hub grease for leakage and water or dust entry.
Checking Brake Fluid Level and Leaks
If fluid level is extremely low, check brake system for leaks.
Checking Brake System
Check brake fluid lines and parking brake cables for improper
attachment, leaks, chafing, abrasion, deterioration, etc.
Checking Brake Booster, Vacuum Hoses,
Connections and Check Valve
Check vacuum lines, connections and check valve for improper
attachment, air tightness, chafing and deterioration.
Checking Disc Brake
Check condition of disc brake components.
ROTOR
Check condition and thickness.
Standard thickness:
26 mm (1.02 in)
Minimum thickness:
24 mm (0.94 in)
SMA946B
SBR991
SMA732A
SBR402A
SMA260A
CHASSIS AND BODY MAINTENANCE
MA-40
CALIPER
Check operation and leakage.
PAD
Check wear or damage.
Standard thickness:
15.5 mm (0.610 in)
Minimum thickness:
2.0 mm (0.079 in)
Checking Drum Brake
Check condition of drum brake components.
WHEEL CYLINDER
Check operation and leakage.
DRUM
Check condition of inner surface.
Nominal diameter:
280 mm (11.02 in)
Maximum diameter:
282 mm (11.10 in)
Out of round maximum:
0.05 mm (0.002 in) or less
LINING
Check wear or damage.
Standard thickness:
Trailing: 3.95 mm (0.16 in)
Leading: 8.95 mm (0.35 in)
Lining wear limit (Minimum thickness):
1.52 mm (0.06 in)
SMA922A
SMA364A
SBR205A
SMA139
SMA138
CHASSIS AND BODY MAINTENANCE
Checking Disc Brake (Cont’d)
MA-41
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст