Nissan Terrano r20e. Manual — part 320
(3) Remove ball joint tightening nuts.
Support lower link with jack.
(4) Separate knuckle spindle from upper and lower links.
Inspection
KNUCKLE SPINDLE
I
Check knuckle spindle for deformation, cracks or other damage
by using a magnetic exploration or dyeing test.
NEEDLE BEARING
I
Check needle bearing for wear, scratches, pitting, flaking and
burn marks.
Installation
I
Install needle bearing into knuckle spindle.
Make sure that needle bearing is facing in proper direction.
Apply multi-purpose grease.
I
Install knuckle spindle to upper and lower ball joints with lower
link jacked up.
CAUTION:
Make sure that oil or grease does not come into contact with
tapered areas of ball joint and knuckle spindle and threads of
ball joint.
I
After installing knuckle spindle, adjust wheel bearing preload.
Refer to “PRELOAD ADJUSTMENT”, “Front Wheel Bearing”,
FA-6.
I
After installing drive shaft, check drive shaft axial end play.
Do not reuse snap ring once it has been removed.
Temporarily install snap ring at same thickness as it was
installed before removal.
Refer to “FRONT AXLE — Drive Shaft”, FA-22.
NFA011
NFA012
SFA929
NFA013
FRONT AXLE — Knuckle Spindle
Removal (Cont’d)
FA-21
Removal and Installation
Removal
1. Remove bolts fixing drive shaft to final drive.
2. Remove
free-running
hub
assembly
with
brake
pedal
depressed. Refer to “FRONT AXLE — Auto-lock Free-running
Hub”, FA-14.
I
Remove brake caliper assembly without disconnecting brake
hydraulic line.
Make sure that brake hose is not twisted.
I
Remove tie-rod ball joint. Refer to “FRONT AXLE — Knuckle
Spindle”, FA-20.
SFA874
SFA236
FRONT AXLE — Drive Shaft
FA-22
3. Remove nuts fixing lower ball joint on lower link.
Support lower link with jack.
4. Remove upper ball joint fixing bolt.
5. Remove shock absorber lower bolt.
6. Remove drive shaft with knuckle.
Cover drive shaft boot with a suitable protector.
7. Separate drive shaft from knuckle by slightly tapping it.
SFA843
SFA842
SFA864
SFA878
SFA879
FRONT AXLE — Drive Shaft
Removal (Cont’d)
FA-23
Disassembly
FINAL DRIVE SIDE
— TS82F type —
1. Remove plug seal from slide joint housing by lightly tapping
around slide joint housing.
2. Remove boot bands.
3. Move boot and slide joint housing toward wheel side, and put
matching marks.
4. Pry off snap ring.
5. Detach spider assembly with press.
SFA880
SFA881
SFA963
SFA964
SFA392
FRONT AXLE — Drive Shaft
FA-24
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст