Nissan Terrano r20e. Manual — part 31
Oil Channel
SAT185B
MAJOR OVERHAUL
AT-121
Locations of Needle Bearings, Thrust Washers
and Snap Rings
NAT225
MAJOR OVERHAUL
AT-122
Disassembly
1. Drain ATF through drain plug.
2. Remove torque converter by holding it firmly and turning while
pulling straight out.
3. Check torque converter one-way clutch.
a. Insert Tool into spline of one-way clutch inner race.
b. Hook bearing support unitized with one-way clutch outer race
with suitable wire.
c. Check that one-way clutch inner race rotates only clockwise
with Tool while holding bearing support with wire.
4. Remove park/neutral position switch from transmission case.
5. Remove oil pan.
I
Always place oil pan straight down so that foreign par-
ticles inside will not move.
6. Place transmission into Tool with the control valve facing up.
SAT018B
NAT226
YAT339
SAT754I
NAT227
DISASSEMBLY
AT-123
7. Check foreign materials in oil pan to help determine cause of
malfunction. If the fluid is very dark, smells burned, or contains
foreign particles, the frictional material (clutches, band) may
need replacement. A tacky film that will not wipe clean indicates
varnish build up. Varnish can cause valves, servo, and clutches
to stick and may inhibit pump pressure.
I
If frictional material is detected, replace radiator after
repair of A/T. Refer to LC section (“Radiator”, “ENGINE
COOLING SYSTEM”).
8. Remove torque converter clutch solenoid valve and A/T fluid
temperature sensor connectors.
I
Be careful not to damage connector.
9. Remove oil strainer.
a. Remove oil strainer from control valve assembly then remove
O-ring from oil strainer.
b. Check oil strainer screen for damage.
10. Remove control valve assembly.
a. Straighten terminal clips to free terminal cords then remove
terminal clips.
SAT171B
NAT228
SAT008B
SAT025B
SAT009B
DISASSEMBLY
Disassembly (Cont’d)
AT-124
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст