Nissan Terrano r20e. Manual — part 325
ACCELERATOR CONTROL, FUEL &
EXHAUST SYSTEM
CONTENTS
ZD30DDTi
. . . . . . ...2
Removal and Installation . . . . . . . . . . . .2
. . . . . . . . . . . . . . . . 3
. . . . . . . . . . . . . . 4
TD27Ti
. . . . . . ...5
Adjusting Accelerator Cable . . . . . . . . . . 5
. . . . . . . . . . . . . . . . 6
Fuel Pump and Gauge . . . . . . . . . . . . 7
. . . . . . . . . . . . . ..10
Removal and Installation
CAUTION:
The accelerator wire should be adjusted when removing and replacing any parts of the accelerator
control system, shown in the illustration.
a. Warm up engine to normal operating temperature. Then stop it.
b. Check to see if throttle valve fully opens when accelerator pedal is fully depressed and if it returns
to idle position when released.
c. Adjust accelerator pedal free play by turning adjusting nut.
d. Check accelerator control parts for improper contact with any adjacent parts.
e. When connecting accelerator wire, be careful not to twist or scratch its inner wire.
f.
Apply a light coat of recommended multi-purpose grease to all sliding or friction surfaces. Do not
apply grease to wire.
g. For ASCD wire adjustment, refer to “ASCD Wire Adjustment” in EL section.
INSPECTION AFTER INSTALLATION
I
Check if accelerator pedal moves smoothly within its range.
I
Check if accelerator pedal returns securely to its original position.
I
Perform “Accelerator Pedal Released Position Learning” when removing the accelerator pedal position
sensor harness connector. Refer to “BASIC SERVICE PROCEDURE” in EC section for instructions.
YFE019
ACCELERATOR CONTROL SYSTEM
ZD30DDTi
FE-2
YFE020
FUEL SYSTEM
ZD30DDTi
FE-3
YFE021
EXHAUST SYSTEM
ZD30DDTi
FE-4
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст