Nissan Terrano r20e. Manual — part 188
System Description
GLOW CONTROL
Engine coolant temperature sensor
E
Engine coolant temperature
ECM
E
Glow relay
E
Glow plugs
Ignition switch
E
Start signal
E
Glow lamp
I
Pre-glow
When the ignition switch is turned on the ON position, the glow
indicator lamp will turn ON and pre-glow starts.
The glow relay is turned ON continuously. The ON time of both
the glow indicator lamp and the glow relay is determined by the
engine coolant temperature. Pre-glow ends when the pre-glow
time elapses or when the engine is started.
I
Intermediate glow
Intermediate glow starts when the pre-glow time has elapsed
and the engine has not been started. The glow relay is turned
ON intermittently. Intermediate glow ends when the intermedi-
ate glow time has elapsed, or when the engine is started.
I
After-glow
After-glow starts as soon as the engine is running and the
engine coolant temperature is below 50°C (122°F). The glow
relay is turned on continuously. After-glow ends when the after-
glow time elapses, or when the engine coolant temperature
exceeds 50°C (122°F).
MEC972D
DTC P0380 GLOW RELAY, DTC P0381 GLOW LAMP
TD27Ti
EC-389
Component Description
GLOW PLUG
The glow plug is provided with a ceramic heating element to obtain
a high-temperature resistance. It glows in response to a signal sent
from the ECM, allowing current to flow through the glow plug via the
glow relay.
On Board Diagnosis Logic
DTC
Malfunction is detected when .
Check Items
(Possible cause)
P0380
0803
I
Glow relay signal circuit is open or shorted.
I
Harness or connectors
(The glow relay signal circuit is open or shorted.)
I
Glow relay
P0381
0908
I
Glow indicator lamp circuit is open or shorted.
I
Harness or connectors
(The glow indicator lamp circuit is open or shorted.)
I
Glow lamp
DTC Confirmation Procedure
WITH CONSULT-II
1) Turn ignition switch “ON” position.
2) Select “DATA MONITOR” mode with CONSULT-II.
3) Wait for at least 5 seconds.
WITHOUT CONSULT-II
1) Turn ignition switch “ON” position and then wait for at least 5
seconds.
2) Turn ignition switch OFF, wait for at least 5 seconds and then
turn on.
3) Perform “Diagnostic Test Mode II” (Self-diagnostic results).
SEF857S
DTC P0380 GLOW RELAY, DTC P0381 GLOW LAMP
TD27Ti
EC-390
Wiring Diagram
LHD MODELS
YEC151A
DTC P0380 GLOW RELAY, DTC P0381 GLOW LAMP
TD27Ti
EC-391
RHD MODELS
YEC152A
DTC P0380 GLOW RELAY, DTC P0381 GLOW LAMP
TD27Ti
Wiring Diagram (Cont’d)
EC-392
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст