Nissan Terrano r20e. Manual — part 66
DATA MONITOR PROCEDURE
1) Turn ignition switch to the OFF position.
2) Connect CONSULT-II to Data Link Connector.
3) Turn ignition switch to the ON position.
1) Touch “START” on CONSULT-II screen.
2) Touch “ABS”.
3) Touch “DATA MONITOR”.
1) Select “SELECT MONITOR ITEM”.
Carry out the monitor test under the condition as described in page BR-62.
C2NCS01
C2SSE01
C2SDM01
C2SMI01
H
H
H
TROUBLE DIAGNOSES
CONSULT-II Inspection Procedure (Cont’d)
BR-61
DATA MONITOR MODE
MONITOR ITEM
CONDITION
SPECIFICATION
FR RH SENSOR
FR LH SENSOR
REAR RH SENSOR
REAR LH SENSOR
Drive vehicle.
(Each wheel is rotating.)
Wheel speed signal
Almost the same speed as speedometer.
STOP LAMP SW
Brake is depressed.
Depress the pedal: ON
Release the pedal: OFF
G-SWITCH
Vehicle is driven.
Vehicle is stopped.
Brake is applied.
When driving or stopping vehicle with a force of less than 0.3G:
ON
When driving or stopping vehicle with a force of 0.3G or more:
OFF
FR RH IN SOL
FR RH OUT SOL
FR LH IN SOL
FR LH OUT SOL
RR IN SOL
RR OUT SOL
1. Drive vehicle at speeds over
30 km/h (19 MPH) for at
least one minute.
2. Engine is running.
Operating conditions for each solenoid valve are indicated.
ABS is not operating: OFF
MOTOR RELAY
ABS is not operating: OFF
ABS is operating: ON
ACTUATOR RELAY
Ignition switch is set to the
“ON” position or engine is run-
ning.
Ignition switch in the “ON” position (Engine stops): OFF
Engine running: ON
WARNING LAMP
Warning lamp is turned on: ON
Warning lamp is turned off: OFF
BATTERY VOLT
Power supply voltage for control unit
TROUBLE DIAGNOSES
CONSULT-II Inspection Procedure (Cont’d)
BR-62
ACTIVE TEST PROCEDURE
I
When conducting Active test, vehicle must be stationary.
I
When ABS warning lamp stays on, never conduct Active test.
1) Turn ignition switch to the “LOCK” position.
2) Connect CONSULT-II to Data Link Connector.
3) Start engine.
1) Touch “START” on CONSULT-II screen.
2) Touch “ABS”.
3) Touch “ACTIVE TEST”.
1) Select active test item by touching screen.
2) Touch “START”.
Carry out the active test by touching screen key.
C2NCS01
C2SSE01
C2SDM01
C2STI01
C2FRS01
H
H
H
TROUBLE DIAGNOSES
CONSULT-II Inspection Procedure (Cont’d)
BR-63
ACTIVE TEST MODE
TEST ITEM
CONDITION
JUDGEMENT
FR RH SOLENOID
FR LH SOLENOID
RR SOLENOID
Engine is running.
Brake fluid pressure control operation
IN SOL
OUT SOL
UP (Increase):
KEEP (Hold):
DOWN (Decrease):
OFF
ON
ON
OFF
OFF
ON
ABS MOTOR
ABS actuator motor
ON: Motor runs (ABS motor relay ON)
OFF: Motor stops (ABS motor relay OFF)
G-SWITCH
Ignition switch is ON or
engine is running.
Check G-switch circuit
OFF: G-switch OFF
ON: G-switch ON
Note: Active test will automatically stop ten seconds after the test starts. (LIMIT SIGNAL monitor shows
ON.)
TROUBLE DIAGNOSES
CONSULT-II Inspection Procedure (Cont’d)
BR-64
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст