Nissan Terrano r20e. Manual — part 282
Inspection
EXHAUST MANIFOLD
Check distortion on mounting surface with straightedge and feeler
gauge.
Limit: 0.2 mm (0.008 in)
INSTALLATION
1. Tighten exhaust manifold holding nuts in the numerical order
shown in the figure.
: 40 - 44 N
⋅
m (4.0 - 4.5 kg-m, 29 - 32 ft-lb)
NOTE:
Install gasket so that the protruding tab (mark for correct
installation) is positioned on the side of No. 1 port (front side).
Refer to component structure diagram on the previous page.
2. Install in the reverse order of removal.
FEM034
EXHAUST MANIFOLD
ZD
EM-19
Removal and Installation
REMOVAL
1. Remove the following parts.
I
Engine cover
I
Intercooler
I
Air inlet pipe
I
Throttle body
I
Wires, harnesses, tubes and pipes
2. Loosen holding bolts in the reverse order of that shown in the
figure and remove.
3. Remove rocker cover to the direction of glow plug tilt.
4. Remove glow plug oil seals.
SEM315G
SEM316G
ROCKER COVER
ZD
EM-20
INSTALLATION
1. Temporarily tighten holding bolts in the numerical order shown
in the figure.
2. Apply Three Bond 1207C (KP510 00150) to the area shown in
the figure.
3. Use a scraper to remove old liquid gasket.
4. Apply once more.
5. Apply engine oil to glow plug oil seals and install them.
6. Tighten holding bolts in the numerical order shown in the figure.
7. Re-tighten to the same torque in the same order as above.
8. Install in the reverse order of removal.
SEM317G
FEM001
SEM316G
ROCKER COVER
ZD
Removal and Installation (Cont’d)
EM-21
Removal and Installation
REMOVAL
1. Drain engine oil.
2. Remove the following parts.
I
Under guard
I
Crossmember, differential member, front final drive assembly
I
Engine gusset
3. Loosen and remove oil pan installation bolts in reverse order of
numbers in the figure.
4. Use a seal cutter (special service tool) to cut away liquid gas-
ket and remove oil pan.
5. Remove oil strainer.
YEM027
JEM773G
OIL PAN & OIL STRAINER
ZD
EM-22
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст