Nissan Titan. Manual — part 58
BRM-54
< UNIT REMOVAL AND INSTALLATION >
REPLACEMENT OPERATIONS
• Front pillar butt joint can be determined anywhere within shaded
area as shown in the figure. The best location for the butt joint is at
position A due to the construction of the vehicle. Refer to the front
pillar section.
• Determine cutting position and record distance from the locating
indent. Use this distance when cutting the service part. Cut outer
front pillar over 60 mm above inner front pillar cut position.
• Prepare a cutting jig to make outer pillar easier to cut. Also, this will
permit service part to be accurately cut at joint position.
• An example of cutting operation using a cutting jig is as follows.
1. Mark cutting lines.
A: Cut position of outer pillar
B: Cut position of inner pillar
2. Align cutting line with notch on jig. Clamp jig to pillar.
3. Cut outer pillar along groove of jig. (At position A)
4. Remove jig and cut remaining portions.
5. Cut inner pillar at position B in same manner.
HOODLEDGE
• Work after radiator core support has been removed.
PIIA0150E
PIIA0151E
PIIA0152E
PIIA0153E
REPLACEMENT OPERATIONS
BRM-55
< UNIT REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
FRONT PILLAR
Work after rear hoodledge reinforcement has been removed.
Change parts:
z
Hoodledge reinforcement
z
Battery mounting reinforcement (RH)
1st body mounting bracket (LH)
z
Hoodledge front reinforcement
z
Harness bracket (RH)
z
Rear hoodledge reinforcement
ALKIA0517GB
BRM-56
< UNIT REMOVAL AND INSTALLATION >
REPLACEMENT OPERATIONS
Front Pillar Outer
ALKIA0516GB
Change parts:
z
Front pillar portion of body side outer
REPLACEMENT OPERATIONS
BRM-57
< UNIT REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
BRM
N
O
P
Front Pillar Brace
ALKIA0515GB
Change parts:
z
Front pillar brace
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст