Nissan Titan. Manual — part 639
DISASSEMBLY
TM-239
< UNIT DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
b. 4WD models
i.
Remove tightening bolts (
) for adapter case assembly and
transmission case.
• Brackets (1)
• Self-sealing bolt (2)
ii.
Tap adapter case assembly using suitable tool.
iii. Remove adapter case assembly (with needle bearing) from
transmission case.
iv. Remove gasket from transmission case.
WCIA0563E
SCIA5201E
SCIA5186E
SCIA5231E
TM-240
< UNIT DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
43. Remove bearing race from output shaft.
44. Remove output shaft from transmission case by rotating left and
right.
45. Remove parking gear from output shaft.
46. Remove seal rings from output shaft.
CAUTION:
Do not reuse seal rings.
47. Remove needle bearing from transmission case.
SCIA5245E
SCIA5030E
SCIA5247E
SCIA5209E
SCIA5031E
DISASSEMBLY
TM-241
< UNIT DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
48. Remove output speed sensor (1) from transmission case.
CAUTION:
• Do not subject it to impact by dropping or hitting it.
• Do not disassemble.
• Do not allow metal filings or any foreign material to get on
the sensor's front edge magnetic area.
• Do not place in an area affected by magnetism.
49. Remove reverse brake snap ring using two flat-bladed screw-
drivers.
NOTE:
Press out snap ring from the transmission case oil pan side gap
using a flat-bladed screwdriver, and remove it using a another
screwdriver.
50. Remove reverse brake retaining plate from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
51. Remove N-spring from transmission case.
52. Remove reverse brake drive plates, driven plates and dish plate
from transmission case.
• Check facing for burns, cracks or damage. If necessary,
replace the plate.
53. Remove snap ring using suitable tool.
: Bolt
JSDIA1321ZZ
SCIA5032E
SCIA5214E
SCIA2322E
SCIA2323E
TM-242
< UNIT DISASSEMBLY AND ASSEMBLY >
DISASSEMBLY
54. Remove spring retainer and return spring from transmission
case.
55. Remove seal rings from drum support.
CAUTION:
Do not reuse seal rings.
56. Remove needle bearing from drum support edge surface.
57. Remove reverse brake piston from transmission case using
compressed air. Refer to
.
CAUTION:
Care should be taken not to abruptly blow air. It makes the
piston incline, and as a result, it becomes hard to disas-
semble the pistons.
SCIA2324E
SCIA3333E
SCIA2796E
SCIA5047E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст