Nissan Xterra. Manual — part 575
REAR SUSPENSION ASSEMBLY
RSU-7
< REMOVAL AND INSTALLATION >
C
D
F
G
H
I
J
K
L
M
A
B
RSU
N
O
P
REMOVAL AND INSTALLATION
REAR SUSPENSION ASSEMBLY
Component
INFOID:0000000009484405
AWEIA0345ZZ
RSU-8
< REMOVAL AND INSTALLATION >
REAR SUSPENSION ASSEMBLY
CAUTION:
When installing the components with rubber bushings, the final tightening of the nuts and bolts must
be done with the vehicle in an unladen condition (the fuel, engine coolant, and engine oil full; the
spare tire, jack, hand tools and mats in their designated positions) with the tires on the ground.
1.
Bumper
2.
Connecting rod
3.
Rear spring shackle
4.
Rear spring shackle bushing
5.
Rear spring bushing (rear)
6.
Rear spring pad
7.
Rear spring bushing (front)
8.
Rear leaf spring
9.
Rear spring clip U-bolts
10. Rear final drive
11. Stabilizer bar
12. Bushing
13. Stabilizer bar clamp
14. Shock absorber
15. Shock absorber (LH)
16. Shock absorber (RH)
17. Dynamic damper
18. Torque arrester (If equipped)
SHOCK ABSORBER
RSU-9
< UNIT REMOVAL AND INSTALLATION >
C
D
F
G
H
I
J
K
L
M
A
B
RSU
N
O
P
UNIT REMOVAL AND INSTALLATION
SHOCK ABSORBER
Removal and Installation
INFOID:0000000009484406
REMOVAL
1. Remove the shock absorber upper and lower nuts and bolts
using power tool.
2. Remove the shock absorber.
INSPECTION AFTER REMOVAL
Inspect the shock absorber for any oil leaks, cracks, or deformations. Replace the shock absorber as neces-
sary.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not reuse shock absorber upper nut.
• Apply multi-purpose grease to the shock absorber upper nut and stud.
Disposal
INFOID:0000000009484407
1. Set shock absorber horizontally with the piston rod fully extended.
2. Drill 2 – 3 mm (0.08 – 0.12 in) hole at the position ( ) from top
as shown to release gas gradually.
CAUTION:
• Wear eye protection (safety glasses).
• Wear gloves.
• Be careful with metal chips or oil blown out by the com-
pressed gas.
NOTE:
• Drill vertically in this direction (
).
• Directly to the outer tube avoiding brackets.
• The gas is clear, colorless, odorless, and harmless.
3. Position the drilled hole downward and drain oil by moving the piston rod several times.
CAUTION:
Dispose of drained oil according to the law and local regulations.
LEIA0120E
Shock absorber upper and lower nuts
: Refer to
(A)
: 20 – 30 mm (0.79 – 1.18 in)
JPEIA0161ZZ
RSU-10
< UNIT REMOVAL AND INSTALLATION >
LEAF SPRING
LEAF SPRING
Removal and Installation
INFOID:0000000009484408
1.
Bumper
2.
Connecting rod
3.
Rear spring shackle
4.
Rear spring shackle bushing
5.
Rear spring bushing (rear)
6.
Rear spring pad
7.
Rear spring bushing (front)
8.
Rear leaf spring
9.
Rear spring clip U-bolts
AWEIA0345ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст