Nissan Xterra. Manual — part 705
IN-CABIN MICROFILTER
VTL-5
< SYSTEM DESCRIPTION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
SYSTEM DESCRIPTION
IN-CABIN MICROFILTER
Description
INFOID:0000000009484327
FUNCTION
The air inside the passenger compartment is filtered by the in-cabin
microfilters when the heater or A/C controls are set on either the
recirculation or fresh mode. The two in-cabin microfilters are located
in the front heater and cooling unit assembly.
REPLACEMENT TIMING
Replacement of the two in-cabin microfilters is recommended on a regular interval depending on the driving
conditions. Refer to
XX-XX, "*****"
. It may also be necessary to replace the two in-cabin microfilters as part of
a component replacement if the in-cabin microfilters are damaged.
LJIA0012E
VTL-6
< PERIODIC MAINTENANCE >
IN-CABIN MICROFILTER
PERIODIC MAINTENANCE
IN-CABIN MICROFILTER
Removal and Installation
INFOID:0000000009484328
REPLACEMENT PROCEDURE
1. Open the lower glove box and press in on the sides so that it will
open completely allowing it to hang by the cord.
2. Gently lift up on the tab (1), then pull the in-cabin microfilter
cover down (2) to remove the cover (3).
CAUTION:
Use care when depressing the tab to avoid damaging it.
3. Remove the in-cabin microfilters from the front heater and cooling unit housing.
4. Insert the first new in-cabin microfilter into the front heater and
cooling unit housing and slide it over to the right. Insert the sec-
ond new in-cabin microfilter into the front heater and cooling unit
housing.
NOTE:
The in-cabin microfilters are marked with air flow arrows. The
end of the microfilter with the arrow should face the rear of the
vehicle. The arrows should point downward.
5. Install the in-cabin microfilter cover, make sure the tab is locked
in place as shown.
6. Close the lower glove box completely.
WLIA0023E
AWIIA1431ZZ
ALIIA0360ZZ
ALIIA0359ZZ
CONTROL UNIT
VTL-7
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
J
K
L
M
A
B
VTL
N
O
P
REMOVAL AND INSTALLATION
CONTROL UNIT
Removal and Installation
INFOID:0000000009484329
FRONT AIR CONTROL
Removal
1. Remove cluster lid C. Refer to
IP-15, "Removal and Installation"
2. Remove the front air control from cluster lid C.
• Remove the four screws (A) that retain the front air control (1)
to cluster lid C.
Installation
Installation is in the reverse order of removal.
ALIIA0361ZZ
VTL-8
< REMOVAL AND INSTALLATION >
INTAKE SENSOR
INTAKE SENSOR
Removal and Installation
INFOID:0000000009484330
REMOVAL
1. Remove the front kick plate. Refer to
INT-18, "Removal and Installation"
2. Remove the front pillar upper finisher. Refer to
INT-18, "Removal and Installation"
.
3. Remove the upper glove box. Refer to
IP-18, "Removal and Installation"
4. Disconnect the harness connector from the intake sensor.
NOTE:
The intake sensor is located on the top of the front heater and
cooling unit assembly next to the A/C evaporator cover.
5. Twist the intake sensor to remove the intake sensor from the
front heater and cooling unit assembly.
INSTALLATION
Installation is in the reverse order of removal.
LJIA0133E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст