Nissan March K13. Manual — part 313
EXL-78
< SYMPTOM DIAGNOSIS >
EXTERIOR LIGHTING SYSTEM SYMPTOMS
SYMPTOM DIAGNOSIS
EXTERIOR LIGHTING SYSTEM SYMPTOMS
Symptom Table
INFOID:0000000005912466
CAUTION:
Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble diag-
nosis if any DTC is detected.
Symptom
Possible cause
Inspection item
Headlamp (HI) is not
turned ON.
One side
• Fuse
• Halogen bulb (HI)
• Harness between IPDM E/R and
the headlamp
• Harness between headlamp and
the ground
• IPDM E/R
Headlamp (HI) circuit
Refer to
Both sides
Symptom diagnosis
“BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON”
Refer to
High beam indicator lamp is not turned ON.
[Headlamp (HI) is turned ON.]
Combination meter
• Combination meter
Data monitor “HI-BEAM IND”
• BCM (HEADLAMP)
Active test “HEADLAMP”
Headlamp (LO) is not
turned ON.
One side
• Fuse
• Halogen bulb (LO)
• Harness between IPDM E/R and
the headlamp
• Harness between headlamp and
the ground
• IPDM E/R
Headlamp (LO) circuit
Refer to
Both sides
Symptom diagnosis
“BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON”
Refer to
Headlamp is not turned
OFF.
When ignition switch
is turned ON.
When ignition switch
is turned OFF.
IPDM E/R
—
Front fog lamp is not
turned ON.
One side
• Front fog lamp bulb
• Harness between front fog lamp
relay and the front fog lamp
• Front fog lamp
• Front fog lamp relay
Front fog lamp circuit
Refer to
Both side
Symptom diagnosis
“BOTH SIDE FRONT FOG LAMPS ARE NOT TURNED ON”
Refer to
Front fog lamp is not turned OFF.
Parking lamp is not turned ON.
• Parking lamp bulb
• Harness between IPDM E/R and
the parking lamp
• IPDM E/R
Parking lamp circuit
Refer to
Tail lamp is not turned ON.
• Tail lamp bulb
• Harness between IPDM E/R and
the rear combination lamp
• Rear combination lamp assembly
• IPDM E/R
Tail lamp circuit
Refer to
License plate lamp is not turned ON.
• License plate lamp bulb
• Harness between IPDM E/R and
the license plate lamp
• License plate lamp assembly
License plate lamp circuit
Refer to
EXTERIOR LIGHTING SYSTEM SYMPTOMS
EXL-79
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
• Parking lamp, tail lamp and license plate lamp
are not turned ON.
• Parking lamp, tail lamp and license plate lamp
are not turned OFF.
(Each illumination is turned ON/OFF.)
Symptom diagnosis
“PARKING, LICENSE PLATE AND TAIL LAMPS ARE NOT TURNED ON”
Refer to
.
Turn signal lamp does
not blink.
Indicator lamp is nor-
mal.
(Applicable side per-
forms the high flasher
activation.)
• Harness between BCM and each
turn signal lamp
• Turn signal lamp bulb
Indicator lamp is in-
cluded.
• Combination switch
• Harness between the combination
switch and BCM
• BCM
Turn signal indicator
lamp does not blink.
(Turn signal indicator
lamp is normal.)
One side
Combination meter
—
Both sides
(Always)
• Turn signal indicator lamp signal
- BCM
• Combination meter
• Combination meter
Data monitor “TURN IND”
• BCM (FLASHER)
Active test “FLASHER”
Both sides
(Only when activating
hazard warning lamp
with the ignition switch
OFF.)
• Combination meter power supply
and the ground circuit
• Combination meter
Combination meter
Power supply and the ground circuit
Refer to
• Hazard warning lamp does not activate.
• Hazard warning lamp continues activating.
(Turn signal is normal.)
• Hazard switch
• Harness between the hazard
switch and BCM
• BCM
Symptom
Possible cause
Inspection item
EXL-80
< SYMPTOM DIAGNOSIS >
BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON
BOTH SIDE HEADLAMPS (HI) ARE NOT TURNED ON
Description
INFOID:0000000005912469
Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.
Diagnosis Procedure
INFOID:0000000005912470
1.
COMBINATION SWITCH INSPECTION
Check the combination switch. Refer to
Is the combination switch normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HEADLAMP (HI) REQUEST SIGNAL INPUT
CONSULT-III DATA MONITOR
1.
Select “HL HI REQ” of IPDM E/R data monitor item.
2.
With operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3.
NO
>> Replace BCM. Refer to
BCS-57, "Removal and Installation"
3.
HEADLAMP (HI) CIRCUIT INSPECTION
Check the headlamp (HI) circuit. Refer to
EXL-62, "Component Function Check"
Is the headlamp (HI) circuit normal?
YES
>> Replace IPDM E/R. Refer to
PCS-28, "Removal and Installation"
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
HL HI REQ
Lighting switch
(2ND)
HI or PASS
ON
LO
OFF
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
EXL-81
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
Description
INFOID:0000000005912471
Both side headlamps (LO) are not turned ON in any condition.
Diagnosis Procedure
INFOID:0000000005912472
1.
CHECK COMBINATION SWITCH
Check the combination switch. Refer to
Is the combination switch normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HEADLAMP (LO) REQUEST SIGNAL INPUT
CONSULT-III DATA MONITOR
1.
Select “HL LO REQ” of IPDM E/R data monitor item.
2.
With operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3.
NO
>> Replace BCM. Refer to
BCS-57, "Removal and Installation"
(Without Intelligent Key).
3.
HEADLAMP (LO) CIRCUIT INSPECTION
Check the headlamp (LO) circuit. Refer to
EXL-64, "Component Function Check"
.
Is the headlamp (LO) circuit normal?
YES
>> Replace IPDM E/R.
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
HL LO REQ
Lighting switch
2ND
ON
OFF
OFF
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст