Nissan March K13. Manual — part 433
LAN-20
< PRECAUTION >
[CAN]
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000005908895
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the “SRS AIR BAG” and
“SEAT BELT” of this Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the “SRS AIR BAG”.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
WARNING:
• When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the
ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s)
with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly
causing serious injury.
• When using air or electric power tools or hammers, always switch the ignition OFF, disconnect the
battery, and wait at least 3 minutes before performing any service.
Precautions for Trouble Diagnosis
INFOID:0000000005908896
CAUTION:
• Never apply 7.0 V or more to the measurement terminal.
• Use a tester with open terminal voltage of 7.0 V or less.
• Turn the ignition switch OFF and disconnect the battery cable from the negative terminal when
checking the harness.
Precautions for Harness Repair
INFOID:0000000005908897
• Solder the repaired area and wrap tape around the soldered area.
NOTE:
A fray of twisted lines must be within 110 mm (4.33 in).
SKIB8766E
LAN
PRECAUTIONS
LAN-21
< PRECAUTION >
[CAN]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
• Bypass connection is never allowed at the repaired area.
NOTE:
Bypass connection may cause CAN communication error. The
spliced wire becomes separated and the characteristics of twisted
line are lost.
• Replace the applicable harness as an assembly if error is detected on the shield lines of CAN communica-
tion line.
SKIB8767E
LAN-22
< SYSTEM DESCRIPTION >
[CAN]
COMPONENT PARTS
SYSTEM DESCRIPTION
COMPONENT PARTS
Component Parts Location
INFOID:0000000005908898
1.
Combination meter
2.
Data link connector
3.
Not applicable
4.
EPS control unit
5.
ABS actuator and electric unit (con-
trol unit)
6.
IPDM E/R
7.
TCM
8.
ECM
9.
BCM
JSMIA0211ZZ
LAN
SYSTEM
LAN-23
< SYSTEM DESCRIPTION >
[CAN]
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
SYSTEM
CAN COMMUNICATION SYSTEM
CAN COMMUNICATION SYSTEM : CAN System Specification Chart
INFOID:0000000005908899
Determine CAN system type from the following specification chart.
NOTE:
Refer to
LAN-14, "Trouble Diagnosis Procedure"
for how to use CAN system specification chart.
×
: Applicable
VEHICLE EQUIPMENT IDENTIFICATION INFORMATION
NOTE:
Check CAN system type from the vehicle shape and equipment.
CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart
INFOID:0000000005908900
LAN-13, "How to Use CAN Communication Signal Chart"
for how to use CAN communication signal
chart.
NOTE:
Refer to
for the abbreviations of the connecting units.
Body type
5-door Hatchback
Axle
2WD
Engine
HR12DE
Transmission
M/T
A/T
Brake control
—
ABS
CAN system type
2
3
4
CAN communication unit
ECM
×
×
×
ABS actuator and electric unit (control unit)
×
IPDM E/R
×
×
×
TCM
×
×
Data link connector
×
×
×
EPS control unit
×
×
×
Combination meter
×
×
×
BCM
×
×
×
1.
ABS warning lamp
A.
With ABS
JSMIA0302ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст