Nissan March K13. Manual — part 317
EXL-94
< REMOVAL AND INSTALLATION >
LIGHTING & TURN SIGNAL SWITCH
LIGHTING & TURN SIGNAL SWITCH
Exploded View
INFOID:0000000005912490
The lighting & turn switch is integrated in the combination switch. Refer to
XX-XX, "*****"
.
SIDE TURN SIGNAL LAMP
EXL-95
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
SIDE TURN SIGNAL LAMP
Exploded View
INFOID:0000000005912491
Removal and Installation
INFOID:0000000005912492
CAUTION:
Disconnect battery negative terminal or remove the fuse.
REMOVAL
1.
Remove the side turn signal lamp in numerical order shown in the figure.
2.
Rotate the bulb socket counterclockwise and unlock it.
NOTE:
Support side turn signal lamp harness with tape so that it won't
fall into the front fender.
INSTALLATION
1.
Rotate the bulb socket clockwise and lock it.
2.
Fix the pawl-side behind the side turn signal lamp housing first, then push the resin clip-side.
Replacement
INFOID:0000000005912493
CAUTION:
• Disconnect battery negative terminal or remove the fuse.
• Never touch the glass of bulb directly by hand. Keep grease and other oily matters away from it.
• Never touch bulb by hand while it is lit or right after being turned off.
• Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect
the performance of lamp. When replacing bulb, be sure to replace it with new one.
SIDE TURN SIGNAL LAMP BULB
1.
Remove the side turn signal lamp.
2.
Rotate the bulb socket counterclockwise and unlock it.
NOTE:
1.
Side turn signal lamp bulb socket
2.
Side turn signal lamp bulb
3.
Side turn signal lamp housing
JPLIA1809ZZ
: Installable both direction
JSLIA0057ZZ
EXL-96
< REMOVAL AND INSTALLATION >
SIDE TURN SIGNAL LAMP
Support the vehicle-side harness of the side turn signal lamp with tape so that it does not drop inside the
front fender.
3.
Remove the bulb from the bulb socket.
HAZARD SWITCH
EXL-97
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
HAZARD SWITCH
Exploded View
INFOID:0000000005912494
Removal and Installation
INFOID:0000000005912495
REMOVAL
1.
Remove the cluster lid C. Refer to
XX-XX, "*****"
.
2.
While pressing pawls, push the hazard switch to remove it.
INSTALLATION
Install in the reverse order of removal.
1.
Cluster lid C
2.
Hazard switch
Pawl
JMLIA1042ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст