Nissan March K13. Manual — part 111
REMOTE KEYLESS ENTRY SYSTEM
DLK-155
< SYSTEM DESCRIPTION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
REMOTE KEYLESS ENTRY SYSTEM
System Diagram
INFOID:0000000005949046
System Description
INFOID:0000000005949047
DOOR LOCK AND UNLOCK OPERATION
• When door lock and unlock button of keyfob is pressed, door lock and unlock signal transmits from keyfob to
BCM via remote keyless entry receiver.
• When BCM receives the door lock and unlock signal, it operates door lock actuator, brinks the hazard lamp
at the same time as a reminder.
OPERATION CONDITION
If the following conditions are satisfied, door lock/unlock operation is performed if the keyfob is operated.
OPERATION AREA
To ensure that the keyfob works effectively, use within 100 cm (3 ft) range of each door, however the operable
range may differ according to surroundings.
HAZARD REMINDER OPERATION
When door is locked or unlocked by keyfob, then BCM blinks hazard warning lamp as a reminder.
How to Change Hazard Reminder Mode
DLK-158, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT)"
.
AUTO DOOR LOCK FUNCTION
After door is unlocked by keyfob button operation and if 30 seconds or more passes without performing the fol-
lowing operation, all doors are automatically locked. However, operation check function does not activate.
JMKIA5392GB
Remote controller operation
Operation condition
Lock
• Key switch is off
• All doors are closed
Unlock
Key switch is off
Remote controller operation
Hazard lamp
Lock
Blinks 1 time
Unlock
Blinks 2 times
Operating condition
• Door switch is ON (door is open)
• Ignition key is inserted in key cylinder
• Door lock/unlock switch is operated
• Keyfob is operated
• Door lock knob is operated
DLK-156
< SYSTEM DESCRIPTION >
[WITHOUT INTELLIGENT KEY SYSTEM]
REMOTE KEYLESS ENTRY SYSTEM
Auto door lock mode can be changed by the “AUTO LOCK SET” mode in “WORK SUPPORT”. Refer to
158, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT)"
.
PANIC ALARM FUNCTION
When key switch in the OFF position, BCM transmits horn reminder signal to IPDM E/R. Then, IPDM E/R
turns on and off horn intermittently.
The horn sounds intermittently.
The alarm automatically turns off.
• After 25 seconds
• When BCM receives any signal from Intelligent Key
How to Change Panic Alarm Operation Mode
DLK-158, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT)"
.
INTERIOR ROOM LAMP CONTROL FUNCTION
Interior room lamp is controlled according to door lock/unlock state, refer to
CONTROL SYSTEM (WITHOUT INTELLIGENT KEY SYSTEM) : System Description"
.
DIAGNOSIS SYSTEM (BCM)
DLK-157
< SYSTEM DESCRIPTION >
[WITHOUT INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
DIAGNOSIS SYSTEM (BCM)
COMMON ITEM
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
INFOID:0000000006062297
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
×
: Applicable item
• *1: For models without NATS this mode is not used.
• *2: This item is displayed, but is not used.
DOOR LOCK
Diagnosis mode
Function Description
Work Support
Changes the setting for each system function.
Self Diagnostic Result
Displays the diagnosis results judged by BCM.
CAN Diag Support Monitor
Monitors the reception status of CAN communication viewed from BCM. Refer to CONSULT-III opera-
tion manual.
Data Monitor
The BCM input/output signals are displayed.
Active Test
The signals used to activate each device are forcibly supplied from BCM.
Ecu Identification
The BCM part number is displayed.
Configuration
• Read and save the vehicle specification.
• Write the vehicle specification when replacing BCM.
System
Sub system selection item
Diagnosis mode
Work Support
Data Monitor
Active Test
Door lock
DOOR LOCK
×
×
Rear window defogger
REAR DEFOGGER
×
×
Warning chime
BUZZER
×
×
Interior room lamp control
INT LAMP
×
×
×
Remote keyless entry system
MULTI REMOTE ENT
×
×
×
Exterior lamp
HEAD LAMP
×
×
×
Wiper and washer
WIPER
×
×
×
Turn signal and hazard warning lamps
FLASHER
×
×
• Automatic air conditioner
• Manual air conditioner
AIR CONDITONER
×
Combination switch
COMB SW
×
Body control system
BCM
×
NATS
IMMU
×
*
1
×
Interior room lamp battery saver
BATTERY SAVER
×
×
×
Back door
TRUNK
×
—
THEFT ALM*
2
×
×
—
RETAINED PWR*
2
Signal buffer system
SIGNAL BUFFER
×
×
Panic alarm
PANIC ALARM
×
DLK-158
< SYSTEM DESCRIPTION >
[WITHOUT INTELLIGENT KEY SYSTEM]
DIAGNOSIS SYSTEM (BCM)
DOOR LOCK : CONSULT-III Function (BCM - DOOR LOCK)
INFOID:0000000005949051
NOTE:
This function is not displayed for models without power door lock system.
DATA MONITOR
ACTIVE TEST
MULTI REMOTE ENT
MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT)
INFOID:0000000005949052
NOTE:
This function is not displayed for models without remote keyless entry system.
WORK SUPPORT
Monitor Item
Contents
IGN ON SW
Indicated [On/Off] condition of ignition switch in ON position
KEY ON SW
Indicated [On/Off] condition of key switch
CDL LOCK SW
Indicated [On/Off] condition of lock signal from door lock unlock switch
CDL UNLOCK SW
Indicated [On/Off] condition of unlock signal from door lock unlock switch
DOOR SW-DR
Indicated [On/Off] condition of front door switch (driver side)
DOOR SW-AS
Indicated [On/Off] condition of front door switch (passenger side)
DOOR SW-RR
Indicated [On/Off] condition of rear door switch RH
DOOR SW-RL
Indicated [On/Off] condition of rear door switch LH
BACK DOOR SW
Indicated [On/Off] condition of back door switch
LOCK STATUS
Indicated [On/Off] condition of driver side door
ACC ON SW
Indicated [On/Off] condition of ignition switch in ACC position
KEYLESS LOCK
Indicated [On/Off] condition of lock signal from key fob
KEYLESS UNLOCK
Indicated [On/Off] condition of unlock signal from key fob
SHOCK SENSOR
NOTE:
This item is indicated, but not monitored
KEY CYL LK-SW
Indicated [On/Off] condition of lock signal from door key cylinder
KEY CYL UN-SW
Indicated [On/Off] condition of unlock signal from door key cylinder
VEHICLE SPEED
Display the vehicle speed signal received from combination meter by numerical value [Km/h]
Test item
Description
DOOR LOCK
This test is able to check door lock/unlock operation
• The all door lock actuators are locked when “ALL LOCK” on CONSULT-III screen is touched
• The all door lock actuators are unlocked when “ALL UNLK” on CONSULT-III screen is touched
Test item
Description
REMO CONT ID REGIST
Keyfob ID code can be registered
REMO CONT ID ERASUR
Keyfob ID code can be erased
REMO CONT ID CONFIR
It can be checked whether Intelligent Key ID code is registered or not in this mode
HAZARD LAMP SET
Hazard reminder function (hazard operation) mode can be changed in this mode
• MODE1: Non-operation
• MODE2: Unlock operation only
• MODE3: Lock operation only
• MODE4: Lock and unlock operation
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст