Nissan Teana J32. Manual — part 198
AV
PRECAUTIONS
AV-647
< PRECAUTION >
[BOSE AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000003960544
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the “SRS AIRBAG” and
“SEAT BELT” of this Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the “SRS AIRBAG”.
• Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Ser-
vice Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness
connectors.
Precaution for Trouble Diagnosis
INFOID:0000000003765979
AV COMMUNICATION SYSTEM
• Do not apply voltage of 7.0 V or higher to the measurement terminals.
• Use the tester with its open terminal voltage being 7.0 V or less.
• Be sure to turn ignition switch OFF and disconnect the battery cable from the negative terminal before
checking the circuit.
Precaution for Harness Repair
INFOID:0000000003765980
AV COMMUNICATION SYSTEM
• Solder the repaired parts, and wrap with tape. [Frays of twisted line
must be within 110 mm (4.33 in).]
• Do not perform bypass wire connections for the repair parts. (The
spliced wire will become separated and the characteristics of
twisted line will be lost.)
PKIA0306E
PKIA0307E
AV-648
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITH NAVIGATION]
AV CONTROL UNIT
ON-VEHICLE REPAIR
AV CONTROL UNIT
Exploded View
INFOID:0000000003765981
REMOVAL
.
DISASSEMBLY
Removal and Installation
INFOID:0000000003765982
REMOVAL
1.
Remove instrument finisher C. Refer to
IP-12, "Removal and Installation"
2.
Remove cluster lid D. Refer to
IP-12, "Removal and Installation"
3.
Remove AV control unit with A/C amp. as a single unit from the body.
4.
Remove bracket screws, and then remove AV control unit.
INSTALLATION
Installation is the reverse order of removal.
1.
AV control unit
2.
Bracket LH
3.
A/C auto amp.
4.
Bracket RH
JPNIA1034ZZ
AV
NAVI CONTROL UNIT
AV-649
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITH NAVIGATION]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
NAVI CONTROL UNIT
Exploded View
INFOID:0000000003765983
DISASSEMBLY
Removal and Installation
INFOID:0000000003765984
REMOVAL
1.
Remove NAVI control unit mounting screws.
2.
Disconnect NAVI control unit connector and remove the NAVI control unit.
INSTALLATION
Install in the reverse order of removal.
1.
NAVI control unit
2.
Bracket LH
3.
Bracket RH
JPNIA1088ZZ
AV-650
< ON-VEHICLE REPAIR >
[BOSE AUDIO WITH NAVIGATION]
DISPLAY UNIT
DISPLAY UNIT
Exploded View
INFOID:0000000003765985
REMOVAL
.
DISASSEMBLY
Removal and Installation
INFOID:0000000003765986
REMOVAL
1.
Remove cluster lid D. Refer to
IP-12, "Removal and Installation"
2.
Remove display unit mounting screws, and then disconnect the display unit connector.
3.
Remove display unit.
INSTALLATION
Installation is the reverse order of removal.
JPNIA1035ZZ
1.
Display unit
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст