Nissan Teana J32. Manual — part 931
PWO-4
< COMPONENT DIAGNOSIS >
POWER SOCKET
POWER SOCKET
Wiring Diagram - POWER SOCKET -
INFOID:0000000003792629
JCMWM1669GB
PWO
POWER SOCKET
PWO-5
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
JCMWM1670GB
PWO-6
< PRECAUTION >
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000003844336
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. Information necessary to service the system safely is included in the “SRS AIRBAG” and
“SEAT BELT” of this Service Manual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the “SRS AIRBAG”.
• Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Ser-
vice Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness
connectors.
PWO
CIGARETTE LIGHTER
PWO-7
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
L
B
A
O
P
N
ON-VEHICLE REPAIR
CIGARETTE LIGHTER
Exploded View
INFOID:0000000003792643
Removal and Installation
INFOID:0000000003792644
REMOVAL
1.
Remove console ashtray assembly. Refer to
.
2.
Remove the screws (A) from reverse side cigarette lighter
socket (1).
3.
Disconnect illumination connector (B) (Models with illumination
connector).
4.
Pull out cigarette lighter (1).
5.
Pull out cigarette lighter socket (2) by pushing the cigarette
lighter ring pawl (A) from the cigarette lighter socket hole
(square) (B).
6.
Remove cigarette lighter ring (3) from console ashtray assembly
while pressing pawls.
INSTALLATION
Install in the reverse order of removal.
NOTE:
Align cigarette lighter socket, cigarette lighter ring and console ashtray assembly cut out.
1
: Cigarette lighter
2
: Cigarette lighter socket
3
: Cigarette lighter ring
JPMIA1024ZZ
JPMIA1028ZZ
C
: Cut out
JPMIA1025ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст