Nissan Teana J32. Manual — part 1055
PRECAUTIONS
SR-3
< PRECAUTION >
C
D
E
F
G
I
J
K
L
M
A
B
SR
N
O
P
• Diagnosis sensor unit must always be installed with their arrow marks “
⇐
” pointing towards the front of the
vehicle for proper operation. Also check diagnosis sensor unit for cracks, deformities or rust before installa-
tion and replace as required.
• The spiral cable must be aligned in the neutral position since its rotations are limited. Do not turn steering
wheel and column after removal of steering gear.
• Handle air bag module carefully. Always place driver and front passenger air bag modules with the pad side
facing upward and seat mounted front side air bag module standing with the stud bolt side facing down.
• Conduct self-diagnosis to check entire SRS for proper functioning after replacing any components.
• After air bag inflates, the front instrument panel assembly should be replaced if damaged.
• Always replace instrument panel pad following front passenger air bag deployment.
Occupant Classification System
INFOID:0000000003751422
Replace occupant classification system control unit and passenger front seat cushion as an assembly.
• With VENTILATION SEAT: Refer to
• Without VENTILATION SEAT: Refer to
SR-4
< PREPARATION >
PREPARATION
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000003838653
Tool number
Tool name
Description
KV99105300
Air bag module bracket
Anchors air bag module
KV99106400
Deployment tool
Disposes of air bag module and front seat
belt pre-tensioner
KV99110500
Deployment tool adapter
• Deployment tool adapter for driver
air bag module (Yellow connector)
• Deployment tool adapter for front
seat belt pre-tensioner (Yellow
connector)
• Deployment tool adapter for side
curtain air bag module (Yellow
connector)
• Deployment tool adapter for front
passenger air bag module
• Connects between the deployment tool
and driver air bag module
• Connects between the deployment tool
and front seat belt pre-tensioner
• Connects between the deployment tool
and side curtain air bag module
• Connects between the deployment tool
and front passenger air bag module
KV99108300
Deployment tool adapter for front
side air bag module
Connects between the deployment tool and
front side air bag module
S-NT354
S-NT357
PHIA0184E
ZZA1166D
PREPARATION
SR-5
< PREPARATION >
C
D
E
F
G
I
J
K
L
M
A
B
SR
N
O
P
Commercial Service Tool
INFOID:0000000003838654
Tool name
Description
Tamper resistant TORX bit
Removes of driver air bag module
Remover tool
Removes clip, pawl and metal clip
S-NT757
PIIB7923J
SR-6
< ON-VEHICLE REPAIR >
DRIVER AIR BAG MODULE
ON-VEHICLE REPAIR
DRIVER AIR BAG MODULE
Exploded View
INFOID:0000000003838665
Removal and Installation
INFOID:0000000003838666
WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3
minutes.
• Always work from the side of air bag module. Never work in front of it.
• Never use air tools or electric tools for servicing.
REMOVAL
1.
Remove the side lids (LH/RH).
2.
Remove the driver air bag module (1) mounting TORX bolt (LH/
RH) with TORX bit (A).
1.
Steering wheel
2.
Side lid (LH/RH)
3.
TORX bolt (LH/RH)
4.
Driver air bag module
Refer to
for symbols in the figure.
JMHIA0613GB
JMHIA0614ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст